燃烧—气体容量法测定冶金石灰中的二氧化碳

冶金石灰是石灰石经过工业煅烧的产品。其二氧化碳含量低，且经过高温煅烧后基本不含有机物。无需按照《石灰石、白云石化学分析国家标准中二氧化碳的化学分析方法》中用酸进行试样分解，只需在1200℃高温中灼烧，使石灰中残留的或煅烧后吸收空气中二氧化碳而形成的碳酸盐分解，象通常测定含碳耐火材料中二氧化碳那样，采用气体容量法进行测定。     

试论安定性不合格消石灰对柔性路面质量的影响

由于过烧石灰的存在和消解不当等原因，造成消石灰安定性不合格，当石灰稳定类路面结构成型或投入使用后，消石灰中的生石灰颗粒开始吸收周围水分，慢慢消解，消解过程中发生体积膨胀，对路面产生破坏。解决石灰安定性问题对防止公路前修后坏，延长路面使用寿命具有积极的现实意义。     

电弧炉采用石灰石单渣冶炼工艺的研究

采用优质石灰石取代质量差的白灰 ,进行了单渣电弧炉熔炼。结果表明 ,钢水成本降低 ,钢水质量提高 ,取得了良好的效果。     

Acidity in upland and hill soils: Cation exchange capacity,pH and lime requirement

For 30 acid upland and hill soils, with initial pH from 3.5 to 5.8, and loss on ignition from 14% to 94%, cation exchange capacity varied with pH according to the relationship CEC = m pH+C, where m and C are characteristic of each soil. The slope m depended on loss on ignition (LOI), and is given by: m=Δ CEC/Δ=0.22 LOI+1.92. Because of these relationships, CEC measured at the natural pH of the soil (in 0.025 M MgSO₄ solution) is more relevant to field conditions than a conventional measurement at pH7. An improved method for estimating lime requirement (LR) of these soils was developed, based on the relationship found between LR and the difference in CEC (ΔCEC) between that at the natural pH of the soil and that at the target pH of 5.5: LR=1.12 ΔCEC+1.48. Lime requirement can therefore also be estimated from loss on ignition using the earlier relationships, and is given by: LR=(0.25 LOI+2.15) Δ+1.48, where Δ is the difference between the natural pH (in 0.025 M MgSO₄) and the target pH. Predictions based on this agreed well with results for a further 10 soils.     

生烧石灰对氧化铝生产过程的影响及石灰炉热工现状分析

由于反苛化作用，生烧石灰对氧化铝生产的循环效率、溶出和蒸发工序有很大的影响。本文对石灰生烧的热工现状进行了热平衡验算，从热工的角度分析了石灰烧制中存在的缺陷，通过热工计算，提出了改善石灰烧制质量的建议，以消除其在生产过程的危害及实现增效的目的。     

伊利石在铝酸钠溶液中的反应脱硅过程研究

为了更清楚地了解伊利石在拜耳法溶出过程中的反应行为，本文对伊利石在合成铝酸钠溶液中的溶出动力学进行了研究，测得其活化能为114，73kJ/mol。并研究了溶液苛性碱浓度对伊利石的反应速率的影响；添加石灰可以有效的增加伊利石的反应率，提高脱硅效率。为拜耳法生产氧化铝的脱硅过程及防止结疤提供理论依据。     

氟化铝生产废水处理工艺的研究

对氟化铝生产废水的处理方法进行了研究。结果表明，一级中和沉淀法和二级中和二级沉淀法均不宜用于氟化铝生产废水的结果，理想的处理方法是碱过量中和酸回调法，辅加氯化钙的石灰乳中和法也可考虑采用。     

以高活性度石灰为原料制备纳米碳酸钙的研究

采用间歇鼓泡碳化法，通过对碳化反应温度、灰乳体积质量、搅拌转速、气体分布器开孔直径、消化浆液陈化时间等影响因素的控制，得到了用高活性度石灰为原料制备纳米碳酸钙的优化工艺条件，制得了平均粒径为15～40nm的纳米碳酸钙产品。     

Effect of particle size on the surface oxidation and flotation behavior of galena particles in lime system

ABSTRACT

In this research, the effect of particle size on the surface oxidation and flotation behavior of galena in the lime system was studied. Coarse (?0.074 + 0.038 mm), intermediate (?0.038 + 0.025 mm) and fine (?0.025 mm) galena particles were used in the experiment. The dissolution tests, flotation tests, and sorption tests were accomplished. Through further analysis by XPS, the effect of particle size and lime was observed. The decrease of mineral particle sizes increased the adsorption ratio of collector and the dissolution of galena, while the hydrophilic product OH^?/Ca(OH)⁺ produced by dissolution occupied the dominant position, which led to the minerals hydrophilic.     

A MECHANISTICALLY BASED MATHEMATICAL MODEL OF SULFUR DIOXIDE ABSORPTION INTO A CALCIUM HYDROXIDE SLURRY IN A SPRAY DRYER

A mathematical model has been developed to predict So₂ absorption and removal during the constant rate drying period of a spray dryer. The model, based on film theory, treats the atomized slurry droplets as spheres containing discrete sorbent particles of slaked lime with the fluid uniformly distributed around the individual particles. The model includes gas and liquid phase mass transfer coefficients as well as resistance to Ca(OH)₂ dissolution. A sensitivity analysis has been conducted and a comparison was made between pilot-scale experimental data and model-predicted values of S0₂ removal efficiency.