GSM无线公话产品中的干扰研究

GSM90 0 /1 80 0固定无线公用电话桌面型话机在开发过程中遇到严重的噪音问题 ,一度成为开发工作的瓶颈。本文就这一噪音问题进行了分析与测试 ,并针对干扰源采取相应的措施 ,在产品开发中付诸应用 ,最终解决了 GSM桌面型无线公话的噪音问题     

无保护间隔的OFDM信道自适应均衡的一种新算法

近年来作为一种特殊的多载波调制方式——正交频分复用(OFDM)已得到越来越多的人的关注.对于传统的OFDM系统来说,如果循环前缀的长度大于信道的时延扩散值,则可以通过简单的频域均衡来解调OFDM信号.可是循环前缀的使用却降低了系统的传输效率,如果能压缩甚至去掉循环前缀,而保持系统性能不变,则是很有意义的,为此本文给出了一种新的均衡结构,利用循环迭代手段以减少甚至去掉循环前缀,最后通过计算机模拟,证实了这种结构的有效性.     

开关磁阻电机调速系统在煤矿井下的应用

随着开关磁阻电机的调速控制系统日臻完善，因其优越性能使得在各行业得到迅速推广，但在煤矿井下的特定环境中使用该调速系统仍存在着诸多问题有待分析研究。     

The treatment of waste-air containing mixed solvent using a biofilter 2. Treatment of waste-air containing ethanol and toluene in a biofilter

An experiment for five stages of a biofilter-run was performed to investigate the effect of hydrophilic ethanol and hydrophobic toluene on the biodegradation of hydrophobic toluene and hydrophilic ethanol, respectively, when waste-air containing toluene and ethanol was treated by a biofilter. Removal efficiencies of toluene and ethanol began to decrease when inlet load surpassed 90 g/m³/h and 100 g/m³/h consistent with maximum elimination capacities of toluene and ethanol, respectively. At the end of the biofilter-run, removal efficiencies for toluene and ethanol were decreased and maintained at 65% and 40%, respectively. The concentration of toluene at 1st sampling port was raised by factor of two in the 3rd stage of the biofilter run when the inlet load of ethanol co-feed was increased by 1.5 times, while the process conditions of toluene were maintained the same as those of the 2nd stage of biofilter-run. According to the result of Mohseni and Allen, it may be interpreted that removal efficiency of hydrophobic toluene was affected by the presence of hydrophilic ethanol when high load of hydrophobic toluene was applied like that of the 1st sampling port of the biofilter. However it was not the case when a low load of hydrophobic toluene was applied like those of the 2nd, 3rd and 4th sampling ports since hydrophobicity of toluene is much less that of α-pinene. Thus, it may be suggested that biodegradation of hydrophobic VOC was interfered by hydrophilic VOC dissolved in the biolayer and the degree of interference was proportional to the inlet load of hydrophobic VOC as well as that of hydrophilic VOC and was inversely proportional to the solubility of hydrophobic VOC. However, it was inferred that the existence of hydrophobic toluene from waste-air can hardly inversely hinder the removal of hydrophilic ethanol in the biofilter when timeevolutions of hydrophilic ethanol concentrations of this experiment were compared with those of the previous experiment of biofilter to treat waste-air containing ethanol only.     

多码CDMA系统中联合并行干扰抵消与迭代信道估计方法

本文针对多码CDMA系统提出了一种联合并行干扰抵消与迭代信道估计方法。该方法首先通过导频符号对信道进行估计，然后使用RAKE接收机后的软信息对信道参数进行修正，最后通过并行干扰抵消(PIC)去除多码干扰(MCI)。仿真结果表明，经过多次迭代后，该方法可显著地降低多码CDMA系统的误比特率平台。本文同时还给出了信道估计质量、码道数和PIC次数对多码CDMA系统性能的影响。     

MC-CDMA系统迭代检测中的一种信道估计算法

在DS—CDMA系统中，联合译码的迭代多用户检测是克服多址干扰增加系统容量的有效方法。本文将多用户检测和译码相结合的迭代检测技术应用于MC—CDMA系统，其中，多用户检测器由串行干扰消除和其后的MMSE滤波器组成。文中提出一种时域信道估计作为迭代初始值的频域信道估计算法，比单纯的频域信道估计方法节约导频符号数量，并且由于信道估计性能的改善，加快了迭代检测的收敛速度。     

An improved method for magnetic identification and localization of cracks in conductors

A SQUID magnetometer can be used to measure the magnetic field produced by flaws in a two-dimensional, conducting plate carrying a current. Identification of the flaw-induced magnetic field is difficult because of the large magnetic field associated with the edges of the plate and the current in the leads that connect the plate to the power supply. We have developed a technique by which the wire and edge fields can be cancelled prior to mapping the magnetic field. In this technique, a similar unflawed conducting sheet is placed adjacent to the flawed plate, with a connection between the sheet and the plate at one edge, and with the opposite edges of the sheet and of the plate connected to the two conductors of a coaxial cable. Thus, an applied current will flow along one conductor of the cable, across the cancelling sheet, cross into the flawed plate, return along the plate, and then return to the power supply along the other conductor of the coaxial cable. As a result of this geometry, there is no magnetic field from the lead-in wires because they are coaxial, and the magnetic field due to the edges of the plate is cancelled by the opposing magnetic field of the edges in the adjacent sheet. The extent of cancellation is determined primarily by the separation between the plate and the cancelling sheet, by the thickness of the plate, and by macroscopic inhomogeneities in their electrical conductivities.     

一种抗干扰能力极强的计算机通信接口电路

设计了一种结构简单，抗干扰能力极强的计算机通信接口电路。该电路利用模拟开关实现了全数字二态电平（1，0）与三态电平(1，0，-1)之间的相互转换；利用模拟开关导通电阻的动态效应以及MOS晶体管开启电压Vτ的衬偏效应，提高了接收电路的抗干扰能力，提出了一种与共模干扰无关的模拟数字混合接收电路。     

Zero aliasing ROM BIST

Signature analyzers are very efficient output response compactors for BIST design. The only limitation of signature analysis is the fault coverage reduction (aliasing) due to the information loss inherent to any data compaction. In this article, in order to increase the effectiveness of ROM BIST, we take advantage from the simplicity of the error patterns generated by ROMs and we show that aliasing free signature analysis can be achieved in ROM BIST.This work was performed when the author was on leave from Minsk Radio Engineering Institute, Computer Department, Belorus.     

Applications of the 4×4 determinant method and the POLYGON ENGINE

In the first half of the paper, various types of processing pertaining to a polygon, using the 4×4 determinant theories are explained along with a new containment test algorithm of a point in a polygon. In the latter half of the paper, a general-purpose geometric processor, the POLYGON ENGINE, is presented which can deal with various types of interference problems, such as Boolean operations in solid modelling, hidden line and surface eliminations, ray tracing and so on. It is, a successor of the TRIANGLE PROCESSOR and is also based upon the 4×4 determinant theories [4–6]. While the TRIANGLE PROCESSOR processes a triangulated polygon on a triangle-by-triangle basis, the POLYGON ENGINE can treat a polygon without triangulation. The latter is expected to be more functional, more efficient and easier to use.