Operation principles for hydrogen spark ignited direct injection engines for passenger car applications

The sustainable reduction of greenhouse gas emissions from road transport requires solutions to achieve net-zero carbon dioxide emissions. Therefore, in addition to vehicles with electrified powertrains, such as those implemented in battery electric of fuel cell vehicles, internal combustion engines fueled with e-fuels or biofuels are also under discussion. An e-fuel that has come into focus recently, is hydrogen due to its potential to achieve zero tank-to-wheel and well-to-wheel carbon dioxide emissions when the electrolysis is powered by electricity from renewable sources. Due to the high laminar burning velocity, hydrogen has the potential for engine operation with high cylinder charge dilution by e.g. external exhaust gas recirculation or enleanment, resulting in increased efficiency. On the other hand, the high burning velocity and high adiabatic flame temperatures pose a challenge for engine cooling due to increased heat losses compared to conventional fuels. To further evaluate the use of hydrogen for small passenger car engines, a series production 1 L 3 cylinder gasoline engine provided by Ford Werke GmbH was modified for hydrogen direct injection. The engine was equipped with a high pressure external exhaust gas recirculation system to investigate charge dilution at stoichiometric operation. Due to limitations of the turbocharging system, very lean operation, which can achieve nitrogen oxides raw emissions below 10 ppm, was limited to part load operation below BMEP = 8 bar. Thus, a reduction of the nitrogen oxides emission level at high loads compared to stoichiometric operation was not possible. At stoichiometric operation with external exhaust gas recirculation engine efficiency can be increased significantly. The comparison of stoichiometric hydrogen and gasoline operation shows a reduced indicated efficiency with hydrogen with significant faster combustion of hydrogen at comparable centers of combustion. However, higher boost pressures would allow to achieve even higher indicated efficiencies by charge dilution compared to gasoline engine operation.     

Intrinsic dielectric behavior of Mg2TiO4 spinel ceramic

In the work, we focused on the intrinsic dielectric behavior of Mg₂TiO₄ spinel ceramic by P–V–L theory and infrared spectra analysis. Ti–O bonds have larger bond ionicity values, thus playing an important role in dielectric polarization. The theoretical dielectric constant was predicted by calculating the bond susceptibility of each chemical bond. Furthermore, Ti(1)–O bonds are responsible for the structural stability of Mg₂TiO₄ ceramic. Based on classical dispersion theory, permittivity and loss corresponding to each infrared active mode were quantified, and then the crucial contribution of low-frequency modes to intrinsic dielectric properties were determined.     

Review of pulsed thermal NDT: Physical principles,theory and data processing

This paper summarizes the basics of pulsed thermal nondestructive testing (TNDT) including theoretical solutions, data processing algorithms and practical implementation. Typical defects are discussed along with 1D analytical and multi-dimensional numerical solutions. Special emphasis is focused on defect characterization by the use of inverse solutions. A list of TNDT terms is provided. Applications of active TNDT, mainly in the aerospace industry, are discussed briefly, and some trends in the further development of this technique are described.     

Time-resolved spectroscopy of infrared active vibrations in 2,5-dioctyloxy poly(phenylene vinylene) films

We report on picosecond time resolved spectroscopy of photogenerated infrared active vibrations in thin films of 2,5-dioctyloxy poly(phenylene vinylene). We excited the films by ?4 ps long pulses of 565 nm laser light with 2×10¹³ photons/cm² per pulse and repetition rate of 76 MHz. We then followed the temporal evolution of the infrared active vibrational (IRAV) spectrum using a subsequent, variably delayed, weak tunable IR probe pulses of similar temporal duration. Under these conditions, we show clear spectroscopic evidence for photogenerated infrared active vibrations at times which are shorter than our temporal resolution (<4 ps). We suggest that the transient IRAV absorption is due to secondary polarons formation following exciton dissociation.     

弹载红外图象处理器中多CPU之间通信方法的研究

弹载红外图象处理器是一个复杂的实时红外图象处理系统。由于它的计算量很大，实时性很强，单ＣＰＵ已经不可能完成如此繁重的任务。本文分析了弹载红外图象处理器中多ＣＰＵ之间通信的几种方法。在分析几种通信方法的原理和各自的优缺点之后，提出了弹载红外图象处理器中多ＣＰＵ之间通信应采用双口ＲＡＭ作共享存储器的并行通信方法，我们所设计的系统中均采用这种方法。实验证明这种方法的数据信息通信具有很高的灵活性和可靠性，完全满足弹载红外图象处理器中多ＣＰＵ之间通信的要求。     

Acidity and basicity of hydrotalcite derived mixed Mg-Al oxides studied by test reaction of MBOH conversion and temperature programmed desorption of NH3 and CO2

Mg-Al hydrotalcites intercalated with five different interlayer anions—CO₃²⁻, SO₄²⁻, Cl⁻, HPO₄²⁻ or terephthalate—were synthesized by either the coprecipitation or ion-exchange method. The structure of the as-synthesized samples and the presence of intended anions in the interlayer gallery of hydrotalcites were determined by X-ray diffraction and FTIR spectroscopy. On calcination at 600 °C the materials were transformed into mixed metal oxides. The kind of the counterbalancing anions present in the parent hydrotalcite influences strongly textural parameters of the obtained Mg-Al oxides. Both temperature-programmed desorption of NH₃ and CO₂, and test reaction of 2-methyl-3-butyn-2-ol (MBOH) conversion were used to determine the acidity and basicity of the samples. The hydrotalcite derived mixed Mg-Al oxides showed the presence of Brønsted and Lewis acid and base sites. However, the strong basic character of the solids caused that acetone and acetylene were observed as the major products of MBOH conversion.     

Room temperature characterization of Hg1-xCdxTe P-on-n heterostructure photodiodes

Measurements of 77K R_oA and 300K reverse bias dynamic impedance (R_dA) products at one volt reverse bias has been carried out to assess the degree of correlation of this figure of merit. Planar P-on-n heterostructures were grown on near lattice-matched CdZnTe substrates with Hg_1-xCd_xTe (0.20< x <0.30) by molecular beam epitaxy. These devices were passivated with CdTe and doped with indium and arsenic as n- and p-type dopants, respectively. Current-voltage characteristic of these devices exhibit thermally generated dark currents at small and modest reverse bias. We have observed that R_oA values of these long wavelength infrared P-on-n heterostructure photodiodes at 77K correlate with room temperature R_dA values. Diode arrays with high room temperature R_dA values at one volt reverse bias also have high R_oA values at 77K. Similarly, low R_dA values at room temperature indicate poor performance at 77K where deviation from diffusion current occurs at reverse bias of 0.2 to 1 volt at room temperature. The results presented here, for a small samples of devices, demonstrate that room temperature measurements of current-voltage characteristics to evaluate Hg_1-xCd_xTe (0.22< x <0.28) diode performance and array uniformity at lower temperatures can be used. This provides an acceptable criteria for further study at lower temperatures.     

红外化学遥感数字信号处理算法的研究进展

介绍了几种为远距离红外蒸汽信号监测开发的分类器设计，频域数字滤波，时域数字滤波等数字信号处理技术。对线性分类器，分段线性分类器和神经网络分类器等在红外化学遥感系统中的应用做了初步的探讨。对背景扣除技术，频域数字滤波技术，数字滤波的切趾方法等做了简要的描述。阐述了时域滤波技术的基本原理及实际应用。展望了红外化学遥感数字信号处理算法的研究前景。     

双波段成象及融合技术研究

概括地分析了双波段成象技术的发展概况，分析了成象技术的基本原理，提出了红外双波段基本方案和涉及的关键技术，分析和计算了系统的基本性能。最后，讨论了双波段及融合技术，认为在双波段实现融合应以自主式结构为主。     

几种新型的光电器件

描述用ＳＯＩ技术制造的光耦合ＭＯＳ继电器和多量子阱长波和红外探测器，以及集成异质结晶体管和激光二管于一体的高增益，高灵敏的光电子开关器件，文中着重介绍这些器件的结构，制造工和器件特性，并对其进行了讨论。