全文获取类型
收费全文 | 1544篇 |
免费 | 29篇 |
国内免费 | 10篇 |
专业分类
电工技术 | 56篇 |
综合类 | 53篇 |
化学工业 | 203篇 |
金属工艺 | 103篇 |
机械仪表 | 84篇 |
建筑科学 | 217篇 |
矿业工程 | 35篇 |
能源动力 | 261篇 |
轻工业 | 128篇 |
石油天然气 | 41篇 |
武器工业 | 4篇 |
无线电 | 69篇 |
一般工业技术 | 142篇 |
冶金工业 | 93篇 |
原子能技术 | 30篇 |
自动化技术 | 64篇 |
出版年
2024年 | 1篇 |
2023年 | 13篇 |
2022年 | 19篇 |
2021年 | 16篇 |
2020年 | 33篇 |
2019年 | 14篇 |
2018年 | 12篇 |
2017年 | 26篇 |
2016年 | 29篇 |
2015年 | 33篇 |
2014年 | 66篇 |
2013年 | 74篇 |
2012年 | 72篇 |
2011年 | 143篇 |
2010年 | 94篇 |
2009年 | 101篇 |
2008年 | 86篇 |
2007年 | 85篇 |
2006年 | 90篇 |
2005年 | 83篇 |
2004年 | 66篇 |
2003年 | 65篇 |
2002年 | 55篇 |
2001年 | 54篇 |
2000年 | 42篇 |
1999年 | 41篇 |
1998年 | 29篇 |
1997年 | 26篇 |
1996年 | 33篇 |
1995年 | 21篇 |
1994年 | 15篇 |
1993年 | 11篇 |
1992年 | 6篇 |
1991年 | 6篇 |
1990年 | 3篇 |
1988年 | 4篇 |
1987年 | 1篇 |
1986年 | 2篇 |
1985年 | 3篇 |
1984年 | 2篇 |
1983年 | 2篇 |
1982年 | 2篇 |
1981年 | 2篇 |
1980年 | 1篇 |
1978年 | 1篇 |
排序方式: 共有1583条查询结果,搜索用时 15 毫秒
1.
This paper proposes a thermoelectric-assisted vapor compression cycle (TVCC) for applications in air-source heat pump systems which could enhance the heating capacity of the system. Performances of TVCC are calculated and then compared with that of basic vapor compression cycle (BVCC). The simulation results show that when coefficients of performance (COPs) of the two cycles are almost equal, the TVCC under maximum COP condition of the thermoelectric modules still performs better than BVCC by 13.0% in heating capacity through selecting the appropriate intermediate temperature. In addition, the TVCC can also achieve an improvement of 16.4%–21.7% in both the heating COP and capacity when compared with the BVCC with an assistant electric heater that is provided with the equivalent power input of thermoelectric heat exchanger. Thus, the TVCC could be beneficial to the applications in small heat pumps if there is always need for auxiliary electric heat. 相似文献
2.
3.
槽孔式水力驱动控制棒槽孔阻力系数实验研究 总被引:2,自引:0,他引:2
对槽孔式水力驱动控制棒槽对孔阻力系数进行了大量实验研究,获得了槽孔式水力驱动控制棒槽对孔阻力系数和其随槽对孔位移的变化规律,分析了槽对孔阻力系数与控制棒槽对孔结构参数之间的关系。结果表明:随槽对孔位移的增加,槽对孔阻力系数从某一较大的定值迅速降低到某一较小的定值,然后再迅速反回到初始的定值,形成一个对称的宽幅波谷;槽高使阻力系数曲线波谷幅宽发生变化,也使完全不重合段的阻力系数发生变化;随内套孔径的增大,阻力系数有所降低,其对阻力系数的影响也进一步减弱。孔径增大到一定程度,阻力系数基本不受孔径参数的影响。 相似文献
4.
1 故障现象一次 ,我们用KL -1 5型制氧制氮车开机制氮 ,给一只容积为 40升、最高工作压力为1 4 7MPa的气瓶灌充氮气 ,当气瓶充气压力升高到一定值时不再上升。反复开泵 ,压力基本不变。液氧泵停止时 ,出口压力无明显下降。经分析判断导致气瓶压力升高到一定值时不再上升的原因是由于液氧泵被冻结所致。2 排除方法首先关闭液氧泵。拧开制冷机氢气放气阀 ,使压力下降到 1 0MPa。开大放气阀 ,使二级压力保持在 0 3 5MPa左右。调整正流空气调节阀 ,调节好中部温度。关闭液氮进液氧泵阀和气氮出液氧泵阀。戴棉布手套 ,拆开液氮进口接头、… 相似文献
5.
This article theoretically investigates the drying of uncoated paper with gas-fired infrared (IR) emitters installed within the drying section of a given commercial paper machine. Specifically, it presents the ideal location of two opposing IR emitters within the drying section. The ideal location of the two opposing IR emitters corresponds to the highest machine speed with specified average moisture content of paper sheet at the end of the drying section. This article also presents the average evaporation rate, temperature, and moisture content of the paper sheet as it travels through the drying section with the two opposing IR emitters operating at the optimum location. In addition, the temperature and moisture profiles in the sheet thickness direction, before and after the IR emitters, are provided. This article is not concerned with the potential effects of drying with IR emitters on paper sheet properties and machine runnability issues. 相似文献
6.
Sung Ho Jeong Joon Jeong Yi Jong Keun Kim Man Yeong Ha 《Journal of Mechanical Science and Technology》1991,5(1):16-21
A computer program to calculate the strip temperature heated in the continuous annealing furnace was developed, using the
zone method for radiative heat transfer analysis with the measured gas temperature in the furnace. Using theF
E Operator, the present study considered the effects of soot and transient species, in addition to the H2O−CO2 gas mixture on the gas radiative heat transfer. The predicted strip temperature distribution forF
E=1.05 represented well the measured data. The maximum difference in the heat flux transfered to the strip from the combustion
gas forF
E=1.0 (without soot and transient species gas radiation) and 1.05 (with soot and transient species gas radiation) was about
15%. The present study also investigated the effects of line speed and thickness variations on the strip temperature, establishing
the bases for the on-line computer model. 相似文献
7.
用发生炉煤气进行快速热风烤窑的应用王善波,王志军(山东荣成市玻搪工程有限公司264309)ProducerGasUsedforFastHeatingupTankFurnace¥WangShanbo;WangZhijun(ShandongRongche... 相似文献
8.
介绍了用于钢管加热炉双交叉限幅燃烧控制的infi90控制系统的构成和通讯网络,基本控制模件CLC04指令回路控制器的硬件结构,软件功能等。 相似文献
9.
介绍应用中频快速感应加热方法对弹簧钢、轴承钢、工模具钢等冷变形抗力大的材料及某些异型材在再结晶温度以下进行温轧的成功经验。利用快速加热还可对轧后需保持原有组织和特性的材料进行轧制。 相似文献
10.