Shock/expansion fan interaction with real gas effects for Earth and Mars atmospheric conditions

Numerical simulations are performed to investigate the real gas effects on shock/expansion fan interaction. Initial perfect gas simulations at low enthalpy capture the flow structures efficiently and outcomes are found to have excellent agreement with the analytical calculations. Furthermore, the simulations with the real gas solver for different enthalpies showed that the variation in enthalpy significantly changes the flow structures. It is observed that an increase in enthalpy leads to a decrease and increase in the postshock and postexpansion fan Mach numbers, respectively. Another important observation is the decrement in the peak pressure ratio with an increment in the enthalpy. These effects are noted to be more pronounced for Mars's environment due to the higher dependency of specific heat on temperature.     

稀土灼烧过程温湿度场仿真分析

影响稀土灼烧工艺的因素十分复杂,关系产品质量稳定及能耗,现行工艺存在优化空间。通过剖析灼烧窑中温度和湿度分布状况,运用κ-ε双方程湍流模型、流体传热、多孔介质传热等理论,按特定组分运输模式,建立灼烧过程质量、动量和能量耦合传递数学模型。设置不同边界导入Fluent环境对数学模型进行仿真试验,完成数据处理实现工艺参数优化。结果表明所建模型能准确反映灼烧窑中温湿度场分布及变化,且最终仿真结果与实际灼烧后的产品湿度含量相符合。     

Full scale investigation of GCL damage mechanisms in small earth dam retrofit applications under earthquake loading

This paper reports results of full scale testing to further explore potential GCL damage mechanisms in earth dam retrofit applications in seismically active areas; in particular, to a) investigate whether shear displacements could reduce the magnitude of GCL panel overlap during earthquake shaking; b) explore the influence of gravel particles on GCL thickness at localised point of contact; and c) observe the consequences of an accidental exposure of an uncovered GCL to short duration rainfall in terms of moisture content and effects during subsequent compaction. The results of these experiments indicate that even under severe shaking no movements were detected at the GCL panel overlap. Whereas gravel particles were observed to locally reduce the thickness of the GCL to 2.2 mm, no plowing of the particle into the GCL occurred due to a lack of shear displacement at the interface, resulting in no localised internal erosion through the barrier. Furthermore, hydration of GCL panels during construction due to surface wetting was observed to result in a state of hydration less than its post-construction state. These results indicate that although each of the three GCL damage mechanisms cannot be ruled out to ever be relevant in practice, the performance of the GCL retrofitted earth dam tested was satisfactory under even severe Level 2 earthquake shaking, and suggests that the retrofitting of small earth dams with GCLs is a promising strategy to improve their static and seismic resistance.     

Performance of a 33m high geogrid reinforced soil embankment without concrete panel

Geosynthetic reinforced soil embankment are extensively applied in the construction of high-speed railway and highway in mountainous regions but limited field monitoring is conducted on high and steep cases. Aiming to acquire better understanding, a 33-m-high single-tiered wrapped-facing geogrid reinforced soil embankment with the slope of 1 V:0.5H in China was monitored for 2 years during and after construction. Vertical earth pressure, strain of geogrids, horizontal displacement and settlement per layer were recorded and analysed. The results show that the geogrid tensile strains gradually increased during construction. And they were still developing after completion due to creep and subsequent vehicle surcharge load. The predictions of reinforcement loads by the FHWA methods were much higher than the estimated ones from measured strains. The vertical earth pressures linearly grew during construction and then stabilized fast. The horizontal displacement increases with height and the largest value achieved around the top of the slope two years after the construction is 0.14% the total height approximately. The settlement per layer is larger in the lower and middle portion of the embankment and no obvious change is observed over time. This study hopes to serve as a case reference for design and construction of similar reinforcement projects in the future.     

煤矸石和硅藻土对熔模石膏型性能的影响

向石膏中加入不同的耐火填料,在同一水膏比下,分别测试分析石膏浆料的流动性、凝结时间,石膏铸粉的湿强度、焙烧后的强度、线收缩率和显微组织。结果表明,煤矸石和硅藻土同时加入石膏粉中,焙烧后的石膏晶粒间搭接良好、紧密度高、铸型强度高。在煤矸石加入量为20%且硅藻土加入量为10%时,石膏浆料的流动直径为90mm,初凝时间为7min,终凝时间为17min,湿抗折强度为2.02MPa,抗压强度为2.3MPa,焙烧后的抗折强度为0.458MPa,抗压强度为1.07MPa,线收缩率为0.320%。     

一种北斗联合低轨星座的导航增强方法研究

单纯依靠北斗导航系统提供定位导航授时服务,存在卫星信号落地功率低、易受遮蔽和阻断的不足。针对此问题,研究了一种北斗联合低轨星座实现导航增强的系统架构;提出了一种新的适应严重遮蔽或干扰条件下,基于到达时间(TOA)和到达频率(FOA)联合观测的定位解算算法;对高中低轨混合星座条件下的覆盖特性和精度衰减因子进行了仿真分析。分析结果表明,用户可见星数平均增加了64.2%,位置精度衰减因子(PDOP)平均改善了28.7%。研究结果可为下一代北斗的论证设计与研制建设提供参考借鉴。     

Thermally driven failure of Nd:YVO4 amplifier crystals

We report on an unusual failure pattern resulting from thermally driven fracture of laser amplifier single crystals. The pattern led to some confusion with regard to the point of initiation due to the coalescence of hackle lines to a region within the fracture surface, rather than the more common divergence of hackle away from the origin. The pattern leads to new fracture terms: Hackle node - the coalescence of hackle marks to a point of prior compression. The feature is produced as a thermally-generated, centrally-located compressive region transforms to tension thereby drawing crack propagation and hackle to the compressive region, forming an internal terminus. Hackle terminus – a hackle node formed by final crack propagation within the component. As part of the analysis, the fracture toughness and slow crack growth constants of neodymium doped, yttrium ortho-vanadate (Nd:YVO₄) were measured. Nd:YVO₄ exhibits slow crack growth and is very brittle with a fracture toughness of only 0.48 MPa√m.     

Real-time analysis and prediction of shield cutterhead torque using optimized gated recurrent unit neural network

An accurate prediction of earth pressure balance (EPB) shield moving performance is important to ensure the safety tunnel excavation. A hybrid model is developed based on the particle swarm optimization (PSO) and gated recurrent unit (GRU) neural network. PSO is utilized to assign the optimal hyperparameters of GRU neural network. There are mainly four steps: data collection and processing, hybrid model establishment, model performance evaluation and correlation analysis. The developed model provides an alternative to tackle with time-series data of tunnel project. Apart from that, a novel framework about model application is performed to provide guidelines in practice. A tunnel project is utilized to evaluate the performance of proposed hybrid model. Results indicate that geological and construction variables are significant to the model performance. Correlation analysis shows that construction variables (main thrust and foam liquid volume) display the highest correlation with the cutterhead torque (CHT). This work provides a feasible and applicable alternative way to estimate the performance of shield tunneling.     

勘探点在Google Earth中显示的程序实现

针对Google Earth的广阔应用前景,提出在Google Earth利用其快速、直观的特点,将勘探点表示在Google Earth上的一种方法,并结合工程实例,将湖北省部分水工环物探项目的勘探点表示在Google Earth上,以利于资料的管理查询。     

建筑房屋动力特性的测试与分析

以大地脉动作为激励振源，对房屋的脉动信号及动力特性进行了测试和分析，指出了通过特殊的仪器，在没有大型激振的情况下，通过分析大地的脉动对结构的影响，可以对房屋进行动力特性的分析。