Simulation and exploration of cavitation process during microalgae oil extracting with ultrasonic-assisted for hydrogen production

Microalgae is promising to be used as feedstock resources for hydrogen production due to its high oil and grease contents. This promotes the development of extraction technology of microalgae oil. In this study, based on the Rayleigh-Plesset equation, the effects of temperature, pressure, ultrasonic power and frequency on the bubble motion of ethanol ultrasound cavitation are investigated. Subsequently, the effects of different process parameters on the extraction rate are studied using Schizochytrium sp. as raw material by stirring or ultrasonic-assisted extraction. And the composition of algae extraction oil is analyzed. The results show that the amplitude of cavitation bubbles increases with the increase of ultrasonic power and decrease of ultrasonic frequency. The extraction rate of algae oil reaches 93.76 ± 0.48% when the ultrasonic power is 150 W, the reaction time is 30 min, the temperature is 50 °C and the liquid-solid ratio is 10:1.     

Removal of Cu2+ from Water Using Liquid-Liquid Microchannel Extraction

The very good extraction selectivity of Cu²⁺ from water was demonstrated with a new microchannel equipment, by employing di-(2-ethylhexyl)phosphoric acid (D2EHPA) as an extractant and kerosene as a solvent. The effects of different experimental parameters on the extraction efficiency E, the volumetric mass transfer coefficient K_La, and the entrainment were experimentally investigated. The results showed that the extraction efficiency increased with increasing temperature, extractant concentration, phase ratio (organic/aqueous), and pH. The total flow rate, phase ratio, and pH were found to have a great effect on the mass transfer, whereas the temperature and the extractant concentration showed little effect.     

纺织品中13种硝基苯类化合物的测试方法

文中建立了超声萃取-反相高效液相色谱法测定纺织品中13种硝基苯类化合物的方法。样品经超声萃取、旋蒸浓缩、定容后,采用高效液相色谱仪(配紫外检测器)进行测试,以保留时间定性,外标法定量。结果表明,该方法的检出限(LOD)为0.01~0.05 mg/kg,方法定量限(LOQ)为0.05~0.20 mg/kg,在一定质量浓度范围内,线性相关系数为0.9979~0.9999;3个不同质量浓度添加试验中,加标回收率为80.50%~104.70%,相对标准偏差(RSD)为2.15%~6.57%(n=6);本方法操作简便,准确度高,回收率及精密度好,适用于纺织品中13种硝基苯类化合物的测定。     

镓锗铜萃余液综合利用研究与应用

本文针对镓锗铜综合回收系统产出的萃余液,设计通过中和氧化除杂、锌粉置换除铜镉、有机试剂除钴镍、纯碱法生产碱式碳酸锌、高温煅烧生产活性氧化锌和一步法生产元明粉的生产工艺流程,有效的将镓锗铜萃余液分类分离富集,产出具有价值的富集渣和工业产品,进一步提升综合回收经济效益。     

抽采孔液态CO2预裂效果显微CT实验研究

为研究液态CO2预裂爆破后,煤体内裂隙发育情况,采用高精度微焦点显微CT系统,对预裂后不同区域的煤样进行CT扫描,并利用Photoshop进行孔裂隙占比统计学分析。研究结果显示,距预裂孔4 m处的煤体裂隙发育明显,孔裂隙占比增加了一倍,而在5 m处的煤体裂隙则发育较弱。表明抽采孔内采取液态C2预裂技术后,4 m范围内的煤体裂隙得到了充分发育,为瓦斯抽采提供了有利条件。     

High areal capacitance of FeOOH-carbon nanotube negative electrodes for asymmetric supercapacitors

The relatively low capacitance of negative electrodes, as compared to the capacitance of advanced positive electrodes, poses a serious problem, since this limits the development of asymmetric supercapacitor (SC) devices with a large voltage window and enhanced power-energy characteristics. We fabricate negative SC electrodes with a high capacitance that match the capacitance of advanced positive electrodes at similar active mass loadings, as high as 37?mg?cm^?2. Cyclic voltammetry, impedance spectroscopy, galvanostatic charge-discharge data and the power-energy characteristics of the asymmetric SC device exhibit good electrochemical performance for a voltage window of 1.6?V. Our approach involves the development and application of particle extraction through liquid-liquid interface (PELLI) methods, new extraction mechanisms and efficient extractors to synthesize α-FeOOH and β-FeOOH electrode materials. The use of PELLI allows agglomerate-free processing of powders, which facilitates their efficient mixing with multiwalled carbon nanotubes (MWCNT) and allows improved electrolyte access to the particle surface. Experiments to determine the properties of FeOOH-MWCNT composites provided insight into the influence of the electrode material and the structure of extractor molecules on the composite properties. The highest capacitance of 5.86?F?cm^?2 for negative electrodes and low impedance were achieved using α-FeOOH-MWCNT composites and a 16-phosphonohexadecanoic acid (PHDA) extractor. This extractor allows adsorption on particles, not only at the liquid-liquid interface, but also in the bulk aqueous phase and can potentially be used as a capping agent for particle synthesis and as an extractor in the PELLI method.     

Extraction of Vanadium(V) from Mixed Chloride/Thiocyanate Solutions with Two Commercial Solvating Extractants

Studies on the extraction and separation of vanadium(V) from mixed hydrochloric acid/ammonium thiocyanate solution with CYANEX 921 and CYANEX 925 in kerosene were carried out. The effects of various factors affecting the extraction process as well as temperature were investigated. Addition of thiocyanate to the chloride solution was found to enhance markedly the extraction of vanadium. HCl solution efficiently stripped V(V). The number of stages required for extraction and stripping of vanadium ions was determined from the McCabe–Thiele diagram. Based on the obtained results, the separation of V(V) from spent catalyst leach indicates the efficiency of the proposed process.     

Better damage of chicory tissue by combined electroporation and ohmic heating for solute extraction

Damage of chicory tissue by combined electroporation and ohmic heating is studied for better solute extraction. Moderate (400–1000 V/cm) and high (10,000 V/cm) PEF treatments were applied varying pause duration between the trains of individual pulses. Ohmic heating was induced with increase of the number of trains N. Temperature dependence of tissue damage degree Z is evaluated for the different PEF intensities. With higher ohmic heating, chicory tissue is faster and better damaged. Electric field strengths of 600–800 V/cm combined with ohmic heating permit to enhance noticeably the solute extraction from chicory tissue. The solute diffusivity D for the different PEF treatments, is nearly the same for same values of Z. Chicory tissue treated to the same damage degree (Z = 0.8–1.0) using different PEF conditions (800, 1000 and 10,000 V/cm) has nearly the same diffusivity.Combined electroporation/ohmic heating pretreatment by moderate PEF (400–1000 V/cm) presents an interesting alterative for the treatment of high product throughputs (e.g. in the case of inulin production from chicory).     

Lycopene-rich cream obtained via high-pressure homogenisation of tomato processing residues in a water–oil mixture

Tomato processing residues are still rich in bioactive compounds that may be recovered and reused, with environmental and economic benefits. This short communication discloses for the first time that the high-pressure homogenisation (HPH) treatment of tomato residues in the presence of water and sunflower oil is able to promote the extraction of bioactive compounds concurrently to the formation of an oil-in-water emulsion stabilised by the micronized residues. The mechanical disruption effect of HPH improved the mass transfer of lycopene into the oil phase, and formed fine fibrous debris, improving stabilisation and visual appearance of the emulsion. Results showed a progressive increase of lycopene concentration in the cream phase up to 5 HPH passes and a concurrent reduction of its content in the pellet. Total polyphenols content and antioxidant activity in the aqueous phase gradually decreased when increasing the number of passes, suggesting their progressive transfer in the cream phase. The proposed process that relies on a purely physical treatment and uses only water/sunflower oil as extraction media resulted in the production of a lycopene-rich cream of potential use as a functional food ingredient.     

基于主曲线的书法字动态重现算法

如何高效逼真地动态重现书法作品的创作过程日益成为亟需解决的问题,因此文中提出基于主曲线的书法字动态重现方法,解决当前细化算法在提取骨架时存在的无效分支较多、不能保证笔画的连续性和准确性的问题.结合书法字自身结构对主曲线算法进行改进和优化.对书法图像进行骨架提取、骨架追踪、笔顺获取等处理,结合骨架信息和二值图像实现笔画宽度复原,针对笔画宽度存在的“肿瘤”问题,提出“角点剔除法”进行修正,结合HTML5的Canvas绘图技术进行书法字动态书写过程.在模拟数据集上的实验表明,文中算法的书法动态重现取得较好效果.