攀西钒钛磁铁矿尾矿制备储水泡沫陶瓷的研究

以攀西钒钛磁铁尾矿和废玻璃为主要原料通过高温烧结法制备储水泡沫陶瓷，研究原料配比和发泡剂（SiC）添加量对材料性能的影响。结果表明:随着钒钛磁铁矿尾矿含量的增加，材料的体积密度及抗压强度逐渐增大，平均气孔孔径逐渐减小；当尾矿添加量为50 wt%，材料的体积吸水率出现极值。当SiC添加量为0.3 wt%，材料内部气孔分布均匀，平均孔径约为2.93 mm。最终以50.0 wt%的钒钛磁铁矿尾矿和50.0 wt%的废玻璃为原料，外加3.0 wt%的石英，0.3 wt%的SiC，3.0 wt%的Na3PO4，在1040℃下制得性能最优的储水泡沫陶瓷，材料的体积密度为0.26 g/cm-3、体积吸水率为56.5%和抗压强度为0.68 MPa。采用SEM、XRD等检测手段研究材料的微观形貌及物相组成，结果表明储水泡沫陶瓷内部由三维立体结构组成，有利于储存水分；材料主要物相包括硅灰石、长石、透辉石和钛铁矿。      

聚氨酯泡沫夹克管生产材料的代用

介绍一种用于生产聚氨酯泡沫夹克管保温层的新材料聚酯聚醚，报道选用这种材料生产泡沫夹克管的工艺及工要工艺参数和产品达到的技术指标及现场应用情况。     

含氚废水水泥固化实验研究

研究用水泥固化处理氚废水,并选择了最佳配方:水与灰的重量比=0.45～0.5,水泥与石膏重量比=5∶1。用IAEA推荐的方法做浸出实验。为了减少水泥固化体中氚的浸出量,实验了几种涂层材料。沥青涂层可将固化体氚的浸出率降低1～2个量级。     

Investigation of the stability of tablets prepared from sucrose and citric acid anhydride utilizing response surface methodology

Inversion of sucrose is a stability problem particularly of candies with acidic taste that contain sucrose and small amounts of organic acids such as citric acid, since the free d-fructose produced by hydrolysis is hygroscopic. The following possibilities were investigated for preventing the hydrolysis of sucrose in tablets containing sucrose and citric acid: Adding various amounts of tri-sodium citrate to the formulation to neutralize the citric acid, (Hot) melt coating of citric acid and tri-sodium citrate with a vegetable fat at different coating ratios, variation of the ratio of coated citric acid and tri-sodium citrate in formulations, and compressing the formulations with different compression forces. After tablet processing and storage of tablets, the concentration of d-fructose was determined on the basis of enzymatic reactions. A response surface central composite design was used. The above-mentioned variations were chosen as independent variables and the amount of d-fructose was chosen as response variable. The lowest rates of inversion could be achieved by increasing the content of tri-sodium citrate and the ratio of coating material and decreasing the ratio of coated citric acid and tri-sodium citrate in the tablet formulations. The compression force had no significant effect on the inversion of sucrose.     

低温促凝剂CN-2的研究与应用

针对低温条件下，水泥浆因候凝时间长，极易造成油、气、水侵，导致固井后水泥环不致密，固井质量差这一现象，研制了一种新型低温复合早强促凝剂CN—2，并完善了与之配套的水泥浆体系，从而满足各类低温条件下的固井施工，为低温浅层油气井固井质量的提高提供了可靠的保证。     

A new formulation for web crippling strength of cold-formed steel sheeting using genetic programming

This study presents Genetic programming (GP) as a new tool for the formulation of web crippling strength of cold-formed steel decks for various loading cases. There is no well established analytical solution of the problem due to complex plastic behaviour. The objective of this study is to provide an alternative robust formulation to related design codes and to verify the robustness of GP for the formulation of such structural engineering problems. The training and testing patterns of the proposed GP formulation are based on well established experimental results from the literature. The GP based formulation results are compared with experimental results and current design codes and found to be more accurate.     

PVC防水卷材的配方研究

研究了利用废旧软聚氯乙烯回收料(旧料)生产PVC塑料防水卷材的配方及其对卷材拉伸性能的影响。结果表明,PVC塑料卷材的拉伸强度和断裂伸长率随PVC树脂添加比例增加而提高,而相同添加量的SG-3型PVC树脂比SG-5型PVC树脂的拉伸性能高；在试验范围内,增塑剂用量增加,卷材的拉伸强度降低,伸长率先升后降；添加CPE能提高PVC卷材伸长率,但拉伸强度有所下降。当CaCO_3用量低于20份时,卷材的拉伸强度和伸长率随CaCO_3添加量增加而提高。PVC防水卷材的优选配方(质量份)：旧料85份,PVC树脂(SG-3型)15份,DOP 5份,CPE 3份,稳定剂(TLS)0．6份,其它助剂适量。     

新型膨化硝铵硫磺工业炸药的研究

用膨化硝酸铵、硫磺、木粉和柴油作原材料，通过建立工业炸药配方设计及最优化数学模型，得到新型膨化硝胺硫横工业炸药配方。通过几种工业炸药的理论参数和实际爆炸性能的比较，得出新型膨化硝铵硫磺工业炸药具有低的成本和优良的爆炸性能。     

普通用途防撕裂钢丝绳芯输送带的研制

介绍了普通用途防撕裂钢丝绳芯输送带的研制。主要包括纵向骨架材料的选择、横向增强层（防撕裂层）的选择、覆盖胶和芯胶及贴胶配方的设计和实际生产工艺。经过试验测试，产品性能符合HG3646－1999标准。该产品已获国家专利。     

国内MDEA溶液的工业应用与前景

介绍了MDEA溶液在气体净化技术中的应用和吸收CO_2机理。在对4家工厂的应用经验进行对比的基础上,认为溶液国产化应当慎重考虑,简单的溶液替代很有可能给生产带来损失,实施的过程应建立在设计研究、建模与中试的基础上,这是国内MDEA净化技术的前景。