| 超低碳贝氏体钢的加工工艺与组织性能分析 |
| |
| 引用本文： | 王建泽,康永林,杨善武,周建. 超低碳贝氏体钢的加工工艺与组织性能分析[J]. 热加工工艺, 2006, 0(8) |
| |
| 作者姓名： | 王建泽 康永林 杨善武 周建 |
| |
| 作者单位： | 北京科技大学材料科学与工程学院 北京100083 |
| |
| 基金项目： | 国家973“提高钢铁质量和使用寿命的冶金学基础研究”基金资助项目(2004CB619102) |
| |
| 摘 要： | 进行了超低碳贝氏体钢的两阶段控轧控冷实验,对轧后钢板进行力学性能检测及组织分析。结果显示,超低碳贝氏体钢强度较高,屈服强度平均达670MPa,伸长率和冲击功偏低;显微组织主要由粒状贝氏体和板条贝氏体组成,两种贝氏体组织只有在两个极端的温度下才有明显的差异,从工程检验的实际出发,不必区分两类贝氏体。
|
| 关 键 词： | 超低碳贝氏体 粒状贝氏体 板条贝氏体 屈服强度 |
Microstructure and Properties Analysis and Process Technology of Ultra Low Carbon Bainite Steel |
| |
| WANG Jian-ze,KANG Yong-lin,YANG Shan-wu,ZHOU Jian. Microstructure and Properties Analysis and Process Technology of Ultra Low Carbon Bainite Steel[J]. Hot Working Technology, 2006, 0(8) |
| |
| Authors: | WANG Jian-ze KANG Yong-lin YANG Shan-wu ZHOU Jian |
| |
| Abstract: | Two stage experiments of controlled rolling and controlled cooling for ultra low carbon bainite(ULCD) were carried out in the laboratory.Mechanical properties were measured and microstructure characters were analyzed.Results show that strength of ULCB is higher,its average yield strength is up to 670MPa,elongation ratio and impact energy of ULCB is lower.Microstructure of ULCB consists of grainular bainite and bainite ferrite.Distinguished differences only exist at extremely temperature.It is unnecessary to differentiate them from the point of view of engineering measure. |
| |
| Keywords: | ultra low carbon bainite granular bainite ferrite bainite yield strength |
| 本文献已被 CNKI 等数据库收录！ |
|
