首页 | 本学科首页   官方微博 | 高级检索  
     

配电网直流定位法探测器的研究与实现
引用本文:张欣,李宝兰,曹盛.配电网直流定位法探测器的研究与实现[J].电子科技,2012,25(11):82-84.
作者姓名:张欣  李宝兰  曹盛
作者单位:(1.湖南省电力公司 常德电业局,湖南 常德 415001;2.湖北省宜昌市供电公司 调度通信中心,湖北 宜昌 443000;3.华北电力大学 电子与通信工程系,河北 保定 071003)
摘    要:在配电网单相接地故障定位中,由于水泥杆接地故障的存在以及导线分布电容的影响,使得C行行波法和交流注入法不能有效定位。直流定位方法是在停电离线状态下,向故障相注入直流信号,然后手持直流信号检测器沿线路检测该直流信号,确定故障点的具体位置。文中对直流信号探测器的原理与组成进行了阐述,并对直流信号的注入进行了仿真。仿真结果表明,该方法是有效、可行的。

关 键 词:配电网  故障定位  直流注入法  直流定位法  

Research on and Implementation of DC Location Detector in Distribution Network
ZHANG Xin,LI Baolan,CAO Sheng.Research on and Implementation of DC Location Detector in Distribution Network[J].Electronic Science and Technology,2012,25(11):82-84.
Authors:ZHANG Xin  LI Baolan  CAO Sheng
Affiliation:(1.Changde Power Bureau,Hunan Electric Power Company,Changde 415001,China; 2.Scheduling Communication Center,Hubei Yichang Electric Power Company,Yichang 443000,China;3.Department of Electronics and Communication Engineering,North China Electric Power University,Baoding 071003,China)
Abstract:In distribution network fault location,the existence of the cement pole earth fault and the effect of wire distribution capacitance make it difficult to locate by the C type traveling wave method and the AC signal injection method.DC signal injection method works in time of line power failure,by which a DC signal is injected into the fault for the maintenance personnel to detect the DC signal by holding a DC signal detector along the road to determine the specific location of the point of failure.The principle of the DC signal detector and composition are described,and the injection of the DC signal is simulated.Simulation results prove the feasibility of our method.
Keywords:distribution network  fault location  DC signal injection method  DC location method
本文献已被 CNKI 维普 万方数据 等数据库收录!
点击此处可从《电子科技》浏览原始摘要信息
点击此处可从《电子科技》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号