| Affiliation: | 1. School of Materials Science and Engineering, Dalian University of Technology, Dalian, Liaoning, 116024, China;2. School of Materials Science and Engineering, Dalian Jiaotong University, Dalian, Liaoning, 116028, China |
| Abstract: | A novel Ti-6.38Al-3.87V-2.43Mo alloy was designed with a cluster formula of 12Al-Ti12] (V0.75Mo0.25Ti2)+4Al-Ti12](Al3) by replacing Ti with Mo/V on the basis of the Ti-Al congruent alloy. The effects of laser power and scanning speed on the molten pool size, surface roughness, relative density, microstructure, and micro-hardness of single-track and bulk Ti-6.38Al-3.87V-2.43Mo samples prepared via laser additive manufacturing (LAM) were investigated. The results show that processing parameters significantly affect the formability, microstructure, and micro-hardness of the alloy. With decreasing laser power from 1,900 W to 1,000 W, the relative density is decreased from 99.86% to 90.91% due to the increase of lack-of-fusion; however, with increasing scanning speed, the relative density does not change significantly, but exceeds 99%. In particular, Ti-6.38Al-3.87V-2.43Mo samples of single-track and bulk exhibit a good formability under an input laser power of 1,900 W and a scanning speed of 8 mm·s-1, and display the lowest surface roughness (Ra=13.33 µm) and the highest relative density (99.86%). Besides, the microstructure of LAM Ti-6.38Al-3.87V-2.43Mo alloy coarsens with increasing laser power or decreasing scanning speed due to the greater input energy reducing the cooling rate. The coarsening of the microstructure decreases the microhardness of the alloy. |
