A Stacking Fault Energy Perspective into the Uniaxial Tensile Deformation Behavior and Microstructure of a Cr-Mn Austenitic Steel

A Cr-Mn austenitic steel was tensile strained in the temperature range 273 K (0 °C) ≤ T ≤ 473 K (200 °C), to improve the understanding on the role of stacking fault energy (SFE) on the deformation behavior, associated microstructure, and mechanical properties of low-SFE alloys. The failed specimens were studied using X-ray diffraction, electron backscatter diffraction, and transmission electron microscopy. The SFE of the steel was estimated to vary between ~ 10 to 40 mJ/m² at the lowest and highest deformation temperatures, respectively. At the ambient temperatures, the deformation involved martensite transformation (i.e., the TRIP effect), moderate deformation-induced twinning, and extended dislocations with wide stacking faults (SFs). The corresponding SF probability of austenite was very high (~10^?2). Deformation twinning was most prevalent at 323 K (50 °C), also resulting in the highest uniform elongation at this temperature. Above 323 K (50 °C), the TRIP effect was suppressed and the incidence of twinning decreased due to increasing SFE. At elevated temperatures, fine nano-sized SF ribbons were observed and the SF probability decreased by an order (~10^?3). High dislocation densities (~10¹⁵ m^?2) in austenite were estimated in the entire deformation temperature range. Dislocations had an increasingly screw character up to 323 K (50 °C), thereafter becoming mainly edge. The estimated dislocation and twin densities were found to explain approximately the measured flow stress on the basis of the Taylor equation.