| 铝薄膜CMP影响因素分析 |
| |
| 引用本文： | 袁育杰,刘玉岭,张远祥,程东升.铝薄膜CMP影响因素分析[J].微纳电子技术,2006,43(2):107-111. |
| |
| 作者姓名： | 袁育杰 刘玉岭 张远祥 程东升 |
| |
| 作者单位： | 河北工业大学微电子研究所,天津,300130 |
| |
| 摘 要： | 提出了在碱性抛光液中铝薄膜化学机械抛光的机理模型,对抛光液的pH值、磨料、氧化剂浓度对过程参数的影响做了一些试验分析。试验结果表面粗糙度的铝薄膜所需的最优化CMP过程参数:硅溶胶粒径为15～20nm,pH值为10.8～11.2,氧化剂浓度为2.5%～3%。
|
| 关 键 词： | 化学机械抛光 铝薄膜 全局平面化 |
| 文章编号： | 1671-4776(2006)02-0107-05 |
| 收稿时间： | 2005-10-12 |
| 修稿时间： | 2005年10月12 |
Influencing Factory Analysis of Al Thin Film CMP |
| |
| YUAN Yu-jie,LIU Yu-ling,ZHANG Yuan-xiang,CHENG Dong-sheng.Influencing Factory Analysis of Al Thin Film CMP[J].Micronanoelectronic Technology,2006,43(2):107-111. |
| |
| Authors: | YUAN Yu-jie LIU Yu-ling ZHANG Yuan-xiang CHENG Dong-sheng |
| |
| Affiliation: | Institute of Microelectronics , Hebei University of Technology, Tianjin 300130, China |
| |
| Abstract: | A model for Al thin film CMP in alkaline polish slurry was introduced. Experimental analysis was performed concerning the influence of process parameters,such as the slurry pH value,the abrasive,the oxidant concentration. Based on the results of the experiments,the optimum conditions of the CMP process parameters for obtaining the planarized Al thin film with sa-tisfactory surface roughness were investigated as follows:the silicon sol diameter was 15～20 nm,the pH value was 10.8～11.2,the oxidant concentration was 2.5%～3%. |
| |
| Keywords: | chemical mechanical polishing aluminum film global planarization |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
