| Autoconer 238型络筒机捻接器工艺参数对结头质量的影响 |
| |
| 引用本文： | 王绍斌,张茂林,刘建文,陈硕.Autoconer 238型络筒机捻接器工艺参数对结头质量的影响[J].棉纺织技术,2000,28(6):23-25. |
| |
| 作者姓名： | 王绍斌 张茂林 刘建文 陈硕 |
| |
| 作者单位： | 西北纺织工学院 |
| |
| 摘 要： | 在Ａｕｔｏｃｏｎｅｒ２８型自动络筒机上改变捻接器工艺参数进行了试验，通过分析试验数据表明：对于一定原料、一定纱号的纱线，适中的退捻气压、加捻气压可使结头强力最大；盲目延长退捻时间会使捻接强力争剧下降；延长加捻时间对结头强力影响不大，但会降低络筒机的效率。
|
| 关 键 词： | 捻接器 工艺参数 络筒机 结头质量 |
| 修稿时间： | 2000-01-20 |
The Influence of Splicer Parameters on Knot Quality of Autoconer 238 Cone Winding Machine |
| |
| Wang Shaobin,Zhang Maolin,Liu Jianwen,Chen Shuo.The Influence of Splicer Parameters on Knot Quality of Autoconer 238 Cone Winding Machine[J].Cotton Textile Technology,2000,28(6):23-25. |
| |
| Authors: | Wang Shaobin Zhang Maolin Liu Jianwen Chen Shuo |
| |
| Affiliation: | Northwest Institute of Textile Science and Technology |
| |
| Abstract: | The change of the processing parameters of splicer on Autoconer 238 automatic winder was tested,the analysis of testing datas showed that,the moderate detwist air pressure and the moderate twist air pressure could obtain the highest knot strength with fixed material and fixed fineness,the blind detwist time delay could rapidly decrease the knot strength,the twist time delay had a little influence on knot strength but could decrease the efficiency of winder. |
| |
| Keywords: | Splicer Processing Parameter Optimum Selection Knot strength Knot diameter Relation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
