Polyaniline nanotubes: conditions of formation

The courses of aniline oxidation with ammonium peroxydisulfate in aqueous solutions of strong (sulfuric) and in weak (acetic) acids, followed by temperature and acidity changes, are different. In solutions of sulfuric acid, granular polyaniline (PANI) was produced; in solutions of acetic acid, PANI nanotubes were obtained. The external diameter of the nanotubes was 100–300 nm, the internal cavity 20–100 nm, and the length extended to several micrometres. The morphology of PANI, granular or tubular, depends on the acidity conditions during the reaction rather than on the chemical nature of the acid. PANI nanotubes were also produced when aniline was oxidized in the absence of any acid. The bulk conductivity of PANI prepared in solutions of acetic acid was 0.08–0.27 S cm^?1, depending on the acid concentration. Protonated PANI prepared in sulfuric and acetic acids were deprotonated with ammonium hydroxide to obtain PANI bases and the ammonium salt of the protonating acid. FTIR spectroscopy showed the differences in the molecular structure of the PANI bases. Irrespective of whether the polymerization was performed in solutions of sulfuric or acetic acid, PANI had hydrogen sulfate counter‐ions only. The PANI morphology is thus not controlled by the nature of counter‐ions. The acidity of the reaction medium determines the protonation of monomer, oligomer and polymer species. The chemistry of aniline oxidation is likely to be affected especially by the protonation of an intermediate in the pernigraniline form. It is proposed that, in the course of aniline oxidation, pH‐dependent self‐assembly of aniline oligomers predetermines the final PANI morphology. Copyright © 2005 Society of Chemical Industry