Nonwoven Ni–NiO/carbon fibers for electrochemical water oxidation

The development of technologically efficient anodes for water oxidation is crucial to improve hydrogen production via water splitting. Electrodes based on metallic active sites dispersed in carbon matrices have been shown to be an attractive way to attain this goal. However, challenges remain to prevent catalyst agglomeration that otherwise can result in a decrease of performance over time.In this work, we report an alternative and efficient method to produce nickel-nickel oxide nanoparticles-embedded in carbon nanofibers (Ni–NiO/C), by the solution blow spinning (SBS) process. Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) analyses show the carbon nanofibrillar matrix as a robust support, with well-dispersed nickel nanoparticles on the surface. The responses of the linear scanning voltammetry, cyclic voltammetry and electrochemical impedance spectroscopy demonstrate how a small fraction of nickel on the fiber surface (≈1.2–5.3%) is enough to promote substantial improvement in performance (η = 278 and 309 mV vs RHE for 10 mA cm^?2) and a significant turnover frequency (TOF) values of 1.38 (η = 278) and 1.30 s^?1 (η = 309). These promising results are correlated with a large amount of Ni³⁺ present on the fiber surfaces, as identified by X-ray Photoelectron Spectroscopy (XPS). This work provides a low-cost and rapid preparation technique that can be extended for the manufacture of a wide variety of electrodes based on metals supported on carbon nanofibers.