| 快速凝固粉末冶金Al－Si－Cu－Mg合金的组织和性能 |
| |
| 引用本文： | 陈桂云,谢赞华,藏志新,张永昌. 快速凝固粉末冶金Al－Si－Cu－Mg合金的组织和性能[J]. 粉末冶金技术, 1994, 0(1) |
| |
| 作者姓名： | 陈桂云 谢赞华 藏志新 张永昌 |
| |
| 作者单位： | 中国科学院金属研究所 |
| |
| 摘 要： | 本文详细论述了快速凝固Ａｌ－１８．６Ｓｉ－４．３４Ｃｕ－０．６６Ｍｇ合金的制备工艺，研究了这种高硅铝合金的力学性能与组织结构的关系。实验结果表明：快速凝固Ａｌ－Ｓｉ－Ｃｕ－Ｍｇ合金的强度、硬度和塑性明显提高，固溶时效处理后的室温拉伸强度高达４３０ＭＰａ。随着试验温度的升高，其拉伸强度下降，但在２００℃时。бｂ能保持在３７０ＭＰａ。Ａｌ－Ｓｉ合金这样优良的高温热稳定性是一般常规高强铝合金难以达到的。
|
| 关 键 词： | 快速凝固，铝硅合金，强度，显微组织 |
STRUCTURES AND PROPERTIES OF RAPIDLY SOLIDIFIED P/M Al-Si-Cu-Mg ALLOY |
| |
| Chen Guiyun,Xie Zanhua,Zang Zhixin and Zhang Yongchang. STRUCTURES AND PROPERTIES OF RAPIDLY SOLIDIFIED P/M Al-Si-Cu-Mg ALLOY[J]. Powder Metallurgy Technology, 1994, 0(1) |
| |
| Authors: | Chen Guiyun Xie Zanhua Zang Zhixin Zhang Yongchang |
| |
| Abstract: | The preparation technology of rapidly solidified Al-18.6Si-4.34Cu-0.66Mg alloy has been described in detail in present paper.The relation between mechanical properties and structures of the high silicon-aluminium alloy was studied.Experimental resultS have shown that the strength, hardness and plasticity of Al-Si alloy were obviously improved. The tensile strength at room temperature reached 430MPa after solid solution and aging treatment. The tensile strength decreased with the increasing of test temperature. However,ab of 370MPa could be kept at 200C. Its wear resistance was increased by three thines when compared with that of hard aluminium.It is difficult to reach such high temperature stability and wear resistance for conventional high strengh aluminium alloy. |
| |
| Keywords: | rapid solidification aluminium-silicon alloy. |
| 本文献已被 CNKI 等数据库收录！ |
