|
|||||
|
|
| 塑料挤吹型胚控制器的设计 | |
| 引用本文： | 高永祥,来建良. 塑料挤吹型胚控制器的设计[J]. 机电工程, 2007, 24(8): 107-108 |
| 作者姓名： | 高永祥 来建良 |
| 作者单位： | 浙江机电职业技术学院,现代制造工程系,浙江,杭州,310053;浙江机电职业技术学院,现代制造工程系,浙江,杭州,310053 |
| 基金项目： | 浙江省杭州市产学研资助项目 |
| 摘 要： | 分析了目前对塑料制品的需求增加,塑料制品结构多样化等现状,提出了具有壁厚控制功能的吹塑成型控制器.并分别从软件系统和硬件系统角度出发,对挤吹成型控制器进行了设计,实现了挤吹成型"高可靠性、高适应性、高效率"的要求. |
| 关 键 词： | 壁厚控制 控制系统 可编程逻辑控制器 比例积分微分 |
| 文章编号： | 1001-4551（2007）08-0107-02 |
| 修稿时间： | 2007-03-19 |
Research of plastic extrude and blow molding controller |
|
| GAO Yongxiang,LAI Jangling. Research of plastic extrude and blow molding controller[J]. Mechanical & Electrical Engineering Magazine, 2007, 24(8): 107-108 | |
| Authors: | GAO Yongxiang LAI Jangling |
| Affiliation: | Department of Modern Manufacturing Engineering, ZheJiang Institute of Mechanical and Electrical Engineering, Hangzhou 310053, China |
| Abstract: | Actuality about plastic product need increasing and complex construct of plastic product was analyzed. Plastic extrude and blow molding was presented, which had the thickness controller. The system was designed and studied by two aspects such as software and hardware to realize the requirements of high reliability, high application and high efficiency. |
| Keywords: | thickness control control system programmable logic controller(PLC) proportional-integral-differential(PID) |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ | |