| 水口出口结构对大方坯连铸结晶器内流体流动的影响 |
| |
| 引用本文： | 徐海伦,文光华,唐萍,于小方,殷皓.水口出口结构对大方坯连铸结晶器内流体流动的影响[J].过程工程学报,2009,9(Z1). |
| |
| 作者姓名： | 徐海伦 文光华 唐萍 于小方 殷皓 |
| |
| 作者单位： | 重庆大学材料科学与工程学院,重庆,400044;南京钢铁股份有限公司电炉厂,江苏,南京,210035 |
| |
| 摘 要： | 基于相似理论,采用0.6:1的缩小水模型研究了采用不同出口结构的水口浇注时连铸大方坯结晶器内钢液、液渣以及气泡的运动行为.结果表明,使用直通型水口浇注时,液面波动较小,液渣层分布均匀,气泡和流股的冲击深度较深,气泡上浮困难,不宜采用吹氩工艺;使用双侧孔水口浇注时,液面波动合理,液渣分布较均匀,流股及气泡冲击深度较浅,流股冲击深度较直通型水口小30 mm左右:采用四侧孔水口浇注时,液面波动均匀,液渣分布均匀且活跃,气泡和流股冲击深度很浅,气泡容易上浮,四侧孔水口适用于浇注内部质量要求较高的钢种.
|
| 关 键 词： | 结晶器 浸入式水口 出口结构 物理模拟 |
Influence of Port Structure of Submerged Entry Nozzle on Fluid Flow for Bloom Continuous Casting Mold |
| |
| XU Hai-lun,WEN Guang-hua,TANG ping,YU Xiao-fang,YIN Hao.Influence of Port Structure of Submerged Entry Nozzle on Fluid Flow for Bloom Continuous Casting Mold[J].Chinese Journal of Process Engineering,2009,9(Z1). |
| |
| Authors: | XU Hai-lun WEN Guang-hua TANG ping YU Xiao-fang YIN Hao |
| |
| Affiliation: | 1. College of Materials Science and Engineering;Chongqing University;Chongqing 400044;China;2. EAF Steelmaking Plant;Nanjing Iron and Steel Co. Ltd.;Nanjing;Jiangsu 210035;China |
| |
| Abstract: | Based on similarity theory,the motion behaviors of liquid steel,liquid slag and bubbles in bloom continuous casting mold were investigated by using 0.6:1 ratio water model. The results showed that when the one-port SEN was used,the level fluctuation was relatively small and the liquid slag distributed uniformly,and the penetration depth of stream and bubbles was deep,so it was difficult for bubbles in mold to float up,blowing argon was not suitable for one-port SEN. When bifurcated nozzle was used,there wer... |
| |
| Keywords: | mold submerged entry nozzle port structure physical modeling |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
