Preparation and densification of superconducting YBa2Cu3Ox ceramics

The solid-state reaction method to form the superconducting oxide YBa₂Cu₃O _x was studied. It was found that the starting cupric and yttrium components accelerated the decomposition of the BaCO₃ component. At a constant heating rate of 10 ° Cmin^–1 in thermogravimetric analysis, the temperature of complete decomposition,T _f, was lowered from greater than 1000 ° C in pure BaCO₃ to between 915 and 985 ° C. The effectiveness in decreasingT _f can be ranked in the order of oxalate, carbonate and oxide. The highest sintered density achieved in this study was 6.03 g cm^–3 (/_th = 95%) at 990 ° C and 5.85 g cm^–3 (/_th = 92%) at 960 ° C. The source of cupric ion had the largest effect on densification. The use of cupric carbonate resulted in a consistently high Archimedes density of about 6.00gcm^–3 and large dimensional shrinkage of about 20% at 990 ° C for 12h. In contrast, the use of cupric oxide gave the lowest density and smallest shrinkage. Within the same powder lot, higher sintered density and smaller dimensional shrinkage were observed in samples with higher initial green density and compaction pressure. However, the data suggested that the enhanced densification and higher density achieved by the use of cupric carbonate and oxalate cannot be accounted for by the different physical characteristics of the powders and the mechanics of powder compaction, measured collectively by the green density.