丁腈橡胶O形密封圈失效原因分析 |
| |
引用本文: | 代晓瑛,雷兴平.丁腈橡胶O形密封圈失效原因分析[J].橡胶科技,2020,18(1):0017-0022. |
| |
作者姓名: | 代晓瑛 雷兴平 |
| |
作者单位: | 航空工业西安飞机工业集团有限责任公司 西安,710089,航空工业西安飞机工业集团有限责任公司 西安,710089 |
| |
摘 要: | 针对飞机油滤系统漏油故障,通过丁腈橡胶O形密封圈外观质量、尺寸、性能、胶料组分和微观形貌测试,分析O形圈失效原因。结果表明:O形圈表面凹痕与O形圈承压能力和装配间隙有关;O形圈内部存在的分层痕迹和异物与生产过程控制不到位有关;O形圈在液压油环境中受到外力作用是其失效的主要原因,破坏形式为疲劳破坏。设定合理的密封压缩量和装配间隙、保证贮存和硫化环境符合要求、提高O形圈密封面加工质量等措施可以预防O形圈失效。
|
关 键 词: | O形密封圈 丁腈橡胶 老化 失效 疲劳 微观形貌 |
收稿时间: | 2019/9/24 0:00:00 |
修稿时间: | 2019/9/24 0:00:00 |
Analysis on Failure Cause of NBR O-Ring |
| |
Authors: | dai xiaoying and LEI Xingping |
| |
Affiliation: | (AVIC Xi’an Aircraft Industry(Group)Co.,Ltd,Xi’an 710089,China) |
| |
Abstract: | In this work,the leakage of aircraft oil filter system was investigated and the causes of acrylonitrile-butadiene rubber O-ring failure were analyzed by visual inspection,dimension measurement,performance test,compound composition analysis and micro morphology analysis of the O-rings.The results showed that,the surface indentation was related to the pressure bearing capacity and assembly clearance of the O-ring.There were stratified traces and foreign matters in the O-rings,which were related to the inadequate control of the production process.The main reason of the failure of O-ring was the external force in the hydraulic oil environment,and the failure mode was fatigue failure.The failure of O-ring could be prevented by setting reasonable sealing compression and assembly clearance,ensuring the storage and curing environment according to requirements,and improving the processing quality of O-ring sealing surface. |
| |
Keywords: | O-ring acrylonitrile-butadiene rubber aging failure fatigue micro morphology |
本文献已被 CNKI 维普 等数据库收录! |
| 点击此处可从《橡胶科技》浏览原始摘要信息 |
|
点击此处可从《橡胶科技》下载全文 |
|