Ferritic stainless steel welding with the A-TIG process

The main advantage of the TIG with flux process (A-TIG welding) is the possibility of obtaining greater penetration of the weld bead while employing the same welding parameters as conventional TIG welding. Various studies have shown the influence of active fluxes on the geometric characteristics of stainless steel austenitic welds. However, little is known about the influence of this process on the geometric and metallurgical characteristics of the weld beads in ferritic stainless steels. In this work, different types of flux are applied when welding ferritic stainless steel with the objective of verifying possible influences on the weld bead's profile, on its visual appearance, on the microstructure, on the hardness of the welded zone and on the impact resistance (Charpy test). The bead-on-plate welds were produced without using any addition metal. Six types of flux were used – one being an oxide produced in a laboratory (TiO₂) and five commercial fluxes. The results showed that use of the flux allows an increase in penetration with significant changes in the appearance of the weld bead. It was also confirmed that the microstructure and the hardness of the weld bead for the steel studied were not affected by the type of flux used, with the microstructure analysed under an optical microscope. The steel in the study showed a high degree of fragility at ambient temperature.