| 散热器上水池拉伸成形工艺及模具 |
| |
| 引用本文： | 杨建华,钱文红,杨世明.散热器上水池拉伸成形工艺及模具[J].模具工业,2003(4):21-23. |
| |
| 作者姓名： | 杨建华 钱文红 杨世明 |
| |
| 作者单位： | 贵州航天凯宏科技有限责任公司,贵州绥阳,563321 |
| |
| 摘 要： | 通过对散热器上水池零件进行拉伸工艺分析 ,阐述了该零件在拉伸成形过程中的难点 ,制定出合理工艺方案及采取有效的工艺措施 ,并还介绍了模具设计参数及要点
|
| 关 键 词： | 上水池 拉伸 措施 设计 |
| 文章编号： | 1001-2168(2003)04-0021-03 |
| 修稿时间： | 2002年10月9日 |
The Drawing Process and the Die for Forming the Top Pool of the Radiator |
| |
| YANG Jian_hua,QIAN Wen_hong,YANG Shi_ming.The Drawing Process and the Die for Forming the Top Pool of the Radiator[J].Die & Mould Industry,2003(4):21-23. |
| |
| Authors: | YANG Jian_hua QIAN Wen_hong YANG Shi_ming |
| |
| Abstract: | Through the analysis of the drawing technology for the top pool part of the auto radiator,the difficult points in the course of drawing the part were stated,a reasonable technological process was worked out and effective technological measures were adopted.The design parameters and the main points for design of the die were introduced. |
| |
| Keywords: | top pool drawing measure design |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
