| 车削中心主轴动静态特性分析 |
| |
| 引用本文： | 李金华,刘永贤,于杨,韩家亮.车削中心主轴动静态特性分析[J].制造技术与机床,2012(3):45-48. |
| |
| 作者姓名： | 李金华 刘永贤 于杨 韩家亮 |
| |
| 作者单位： | 东北大学机械工程与自动化学院;辽宁工业大学机械工程学院 |
| |
| 基金项目： | 国家科技重大专项(2009ZX04001-053) |
| |
| 摘 要： | 以车削中心主轴为研究对象,采用弹簧阻尼单元模拟动静压轴承支承的方法,建立主轴三维有限元参数化模型。同时进行静力学分析、模态分析,分别得到静刚度、固有频率和振型,并通过谐响应分析,比较了主轴在共振和设计工况下的振型,找出该主轴的危险点并进行了相关验算。
|
| 关 键 词： | 车削中心 主轴 模态分析 谐响应 |
Static and dynamic characteristic analysis of spindle in turning center |
| |
| LI Jinhua①②,LIU Yongxian①,YU Yang①,HAN Jialiang.Static and dynamic characteristic analysis of spindle in turning center[J].Manufacturing Technology & Machine Tool,2012(3):45-48. |
| |
| Authors: | LI Jinhua①② LIU Yongxian① YU Yang① HAN Jialiang |
| |
| Affiliation: | ①(①School of Mechanical Engineering & Automation,Northeastern University,Shenyang 110004,CHN;②School of Mechanical Engineering,Liaoning University of Technology,Jinzhou 121001,CHN) |
| |
| Abstract: | The spindle of turning center is researched,and the spring-damper elements are used to simulate the bearing supports.Based on the FEA parametric model of the spindle,it is to finish the static analysis and model analysis,and gains static stiffness,natural frequency and modes.Harmonic response is used to simulate the dynamic responses on the first set natural frequency and the maximum speed which is designed for the machine.Compared of two modes,the key points of spindle design performance are calculated and checked. |
| |
| Keywords: | Turning Center Spindle Modal Analysis Harmonic Response |
| 本文献已被 CNKI 等数据库收录！ |
|
