| 销钉机筒挤出机塑化段传热温度模型研究 |
| |
| 引用本文： | 陈可娟,梁树炯.销钉机筒挤出机塑化段传热温度模型研究[J].橡胶工业,2007,54(7):430-433. |
| |
| 作者姓名： | 陈可娟 梁树炯 |
| |
| 作者单位： | 华南理工大学,工业装备与控制工程学院,广东,广州,510641 |
| |
| 摘 要： | 通过建立简化的销钉机筒挤出机塑化段物理模型，从流变分析中的能量方程出发，导出销钉机筒挤出机塑化段温度的传热模型；结合试验数据，拟合出挤出温度随螺杆转速变化的曲线。结果表明，曲线可分为急速增长段、平缓增长段和稳定增长段3部分，且平缓增长段是挤出温度、质量和能耗综合指标最佳的区间。
|
| 关 键 词： | 销钉机筒挤出机 传热温度模型 挤出温度 塑化 |
| 文章编号： | 1000-890X（2007）07-0430-04 |
| 修稿时间： | 2007-01-15 |
Research of heat exchange model for the plasticating zone in pin barrel extruder |
| |
| CHEN Ke-juan and LIANG Shu-jiong.Research of heat exchange model for the plasticating zone in pin barrel extruder[J].China Rubber Industry,2007,54(7):430-433. |
| |
| Authors: | CHEN Ke-juan and LIANG Shu-jiong |
| |
| Affiliation: | South China University of Teehnology,Guangzhou 510641,China |
| |
| Abstract: | Based on the simplified physical model of the plasticizing zone in pin barrel extruder,and according to the energy equation in the field of rheology analysis,the heat transfer model of the plasticizing zone in pin barrel extruder was established.The results showed that curve fitting could be split into 3 sections:burgeoning section,mildly increase section and steady increase section.The mildly increase section showed the best comprehensive condition of extruding temperature,quality and energy consumption. |
| |
| Keywords: | pin barrel extruder heat transfer model extruding temperature plastication |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
| 点击此处可从《橡胶工业》浏览原始摘要信息 |
|
点击此处可从《橡胶工业》下载全文 |
