| 基于翘曲的注塑成型工艺参数优化组合 |
| |
| 引用本文： | 曾亚森,何和智.基于翘曲的注塑成型工艺参数优化组合[J].高分子材料科学与工程,2009(6). |
| |
| 作者姓名： | 曾亚森 何和智 |
| |
| 作者单位： | 中山火炬职业技术学院;华南理工大学聚合物新型成型装备国家工程研究中心; |
| |
| 基金项目： | 广东省自然科学基金资助项目(04011554) |
| |
| 摘 要： | 采用Taguchi方法设计注塑成型模拟实验,以注塑成型工艺参数混合优化模块方法确定工艺参数最优组合。先建立注塑成型工艺参数混合优化模块,按L9(34)正交表进行实验,得到熔体温度、保压压力、注射时间、成型周期时间等参数不同水平时的翘曲和收缩率数据,翘曲量和收缩率都属于望小特性,计算出S/N比,通过S/N比反应图分析得出较优工艺参数组合,再实验验证确定最优组合,最后说明注塑成型工艺参数混合优化模块方法可行。
|
| 关 键 词： | 翘曲 工艺参数 组合 Taguchi 优化模块 |
Optimal Combination of Injection Molded Process Parameter Based on Warp |
| |
| ZENG Ya-sen,HE He-zhi.Optimal Combination of Injection Molded Process Parameter Based on Warp[J].Polymer Materials Science & Engineering,2009(6). |
| |
| Authors: | ZENG Ya-sen HE He-zhi |
| |
| Affiliation: | 1.Zhongshan Torch Polytechnic;Zhongshan 528436;China;2.National Engineering Research Center of Novel Equipment for Polymer Processing;South China University of Technology;Guangzhou 510640;China |
| |
| Abstract: | To design injection molded products simulative with Taguchi.Optimization process parameter combination obtains with injection molded process parameter mixed optimizing module.This optimizing module set up.Experiment design used L9(34)orthogonal arrays.Warp data and volumetric shrinkage data of melt temperature,packing pressure,injection time and molding period time had gained for different level.Attribute of warp and volumetric shrinkage is smaller-the-better type characteristic.S/N ratio was conducted to d... |
| |
| Keywords: | warp process parameter combination Taguchi optimizing module |
| 本文献已被 CNKI 等数据库收录！ |
