| 基于冲压成形分析的横梁拉深模设计 |
| |
| 引用本文： | 喻旻.基于冲压成形分析的横梁拉深模设计[J].模具工业,2011,37(3):44-47. |
| |
| 作者姓名： | 喻旻 |
| |
| 作者单位： | 湖北汽车工业学院材料工程系,湖北,十堰,442002 |
| |
| 摘 要： | 以汽车覆盖件为研究对象,根据板料成形特点,利用PAM_STAMP软件对横梁冲压过程进行数值模拟,确定最佳工艺参数后,用UG NX6软件完成横梁的拉深模设计,模具结构合理。
|
| 关 键 词： | 覆盖件 模具设计 PAM_STAMP UG |
Design of die for crossbeam based on analysis of stamping process |
| |
| YU Min.Design of die for crossbeam based on analysis of stamping process[J].Die & Mould Industry,2011,37(3):44-47. |
| |
| Authors: | YU Min |
| |
| Affiliation: | YU Min(Department of Materials Science and Engineering,Hubei University of Automotive Technology,Shiyan,Hubei 442002,China) |
| |
| Abstract: | The stamping process of a crossbeam in an automobile panel was simulated according to the characteristic of sheet forming.A drawing die for the stamping was developed by using UG NX6 software atter optimum technological parameters were determined. |
| |
| Keywords: | PAM-STAMP UG |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
