| 基于线框电极的电火花直孔套料加工研究 |
| |
| 引用本文： | 徐盛林,胡磊,杨俊杰,余五新. 基于线框电极的电火花直孔套料加工研究[J]. 现代制造工程, 2005, 0(4): 79-81 |
| |
| 作者姓名： | 徐盛林 胡磊 杨俊杰 余五新 |
| |
| 作者单位： | 武汉经济技术开发区江汉大学研究生处,430056 |
| |
| 摘 要： | 试验研究一种使用线框电极的电火花加工的新工艺———套料加工。根据正交试验原理设计了混合位级正交表来试验和分析粗加工时电加工参数对加工速度和电极损耗率的影响,以确定线框电极套料加工时最佳电规准参数。最后依据试验数据绘出了三维图形,更加直观地表达了试验的结果。
|
| 关 键 词： | 电火花 套料加工 正交试验 线框电极 |
| 文章编号： | 1671-3133(2005)04-0079-03 |
| 修稿时间： | 2004-09-29 |
A research on the hole machined by electric discharge with frame electrode |
| |
| Xu Shenglin,Hu Lei,Yang Junjie,Yu Wuxin. A research on the hole machined by electric discharge with frame electrode[J]. Modern Manufacturing Engineering, 2005, 0(4): 79-81 |
| |
| Authors: | Xu Shenglin Hu Lei Yang Junjie Yu Wuxin |
| |
| Abstract: | A new process on EDM is investigated in this experiment, in which a copper frame electrode is used. And the basic principle of the orthogonal test was used to design an abnormal mixed orthogonal test table to conduct the experiment and analyse the effect of process parameters on the material removal rate (MRR) and the electrode wear of copper frame electrode processing in rough process. The optimum process parameters by copper frame electrode machining were found out according to the experimental data analysis. An envelope figure of experimental data is generated with the software of ORIGIN, and it would make the observation more directly. |
| |
| Keywords: | Electrical discharge machining Frame processing Orthogonal experiment Copper frame electrode |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
