| Abstract: | Filled polymer composites have been prepared in which the energetics of the filler surfaces was systematically varied in order to investigate the dependence of the mechanical properties of the composite on the interfacial strength as predicted by the thermodynamic work of adhesion at the filler-matrix interface. A high-purity silica filler was used, treated with three different organofunctional silane coupling agents (two alkylsilanes and an aminosilane) to varying degrees from zero to complete coverage. The surface energetics of the modified fillers was characterized using both inverse gas chromatography (IGC) and dynamic contact angle analysis (DCA). While the surface energy assessments from IGC were higher than those obtained with wetting measurements, as expected, the trends with fractional coverage of silane were the same for each method, and were used to evaluate the thermodynamic work of adhesion. Highly filled polymer composites were prepared by dispersing the variously treated silica fillers into the amorphous thermoplastic matrix polymers: poly(methyl methacrylate) and poly(vinyl butyral). Specimens of the composites were tested mechanically to give the yield stress. The poly(methyl methacrylate) composites all failed cohesively in the matrix, unaffected by any of the filler surface treatments. The poly(vinyl butyral) composites, however, all displayed purely interfacial failure, with the yield stress strongly dependent on the type and extent of the filler surface treatment. While all three silanes were found to decrease the filler surface energy, and consequently the thermodynamic work of adhesion, with higher surface coverage, corresponding decreases in the yield stress were found only for the alkylsilanes. For the aminosilane, the measured yield stress was found to increase with surface coverage and therefore to decrease with the work of adhesion. The difference in behavior between the two types of coupling agent is explained in terms of acid-base effects. |
