| 不同焊接方法对TWIP钢焊后热影响区组织和性能的影响 |
| |
| 引用本文： | 米振莉,杨林,李志超,江海涛.不同焊接方法对TWIP钢焊后热影响区组织和性能的影响[J].焊接学报,2013,34(5):9-12. |
| |
| 作者姓名： | 米振莉 杨林 李志超 江海涛 |
| |
| 作者单位： | 北京科技大学冶金工程研究院,北京,100083 |
| |
| 基金项目： | 国家863高技术研究发展计划资助项目 |
| |
| 摘 要： | 文中对Fe-Mn-C系TWIP钢的焊接行为进行了系统研究,采用激光焊和钨极氩弧焊(TIG)进行了焊接试验,对两种焊接方法的焊后热影响区的显微组织及力学性能进行了分析.结果表明,激光焊后焊接热影响区(HAZ)及焊缝组织更为细小,分布也更为均匀,断后伸长率明显好于TIG焊.焊缝的显微硬度要高于HAZ和母材,TIG焊后HAZ晶粒严重长大,显微硬度在HAZ处也明显降低,出现了软化,导致综合性能偏差.
|
| 关 键 词： | 孪晶诱导塑性钢 钨极氩弧焊 激光焊 热影响区 |
| 收稿时间： | 2012/4/16 0:00:00 |
Study on heat-affected zone of TWIP steel after welding |
| |
| MI Zhenli,YANG Lin,LI Zhichao and JIANG Haitao.Study on heat-affected zone of TWIP steel after welding[J].Transactions of The China Welding Institution,2013,34(5):9-12. |
| |
| Authors: | MI Zhenli YANG Lin LI Zhichao and JIANG Haitao |
| |
| Affiliation: | Metallargical Engineering Research Institute, University of Science and Technology Beijing, Beijing 100083, China,Metallargical Engineering Research Institute, University of Science and Technology Beijing, Beijing 100083, China,Metallargical Engineering Research Institute, University of Science and Technology Beijing, Beijing 100083, China and Metallargical Engineering Research Institute, University of Science and Technology Beijing, Beijing 100083, China |
| |
| Abstract: | In this paper,microstructure and mechanical properties were analyzed on the heat-affected zone (HAZ) of the sheets obtained by applying laser beam and TIG welding. The result shows that microstructure of HAZ and fusion zone (FZ) becomes finer and distributes more uniformly and the elongation is significantly better than that of TIG welding. Microhardness of FZ is larger than that of the base metal. Grains of TIG welding in HAZ grow a lot,and microhardness is significantly reduced in the HAZ which leads to worse comprehensive performance. |
| |
| Keywords: | twinning induced plasticity tungsten inert gas welding laser beam welding heat affected zone |
| 本文献已被 万方数据 等数据库收录！ |
| 点击此处可从《焊接学报》浏览原始摘要信息 |
|
点击此处可从《焊接学报》下载全文 |
|
