Measurement of styrene oxide in polystyrenes, estimation of migration to foods, and reaction kinetics and products in food simulants

The concentration of styrene-7,8-oxide has been measured in nine base resins and 16 samples of polystyrene articles intended for food contact. The epoxide was not detected in the resins (limit of detection 0.5 mg/kg) but was found in 11 of the 16 packaging samples at up to 2.9 mg/kg. Assuming that the propensity of styrene oxide to migrate is the same as styrene monomer, and using existing survey data for styrene monomer in packaging and foods, the migration levels expected for styrene oxide were calculated. Estimates were from 0.002 to 0.15 microgram/kg styrene oxide in foods. The stability of styrene oxide in the four standard EU food simulants was studied at 40, 100, 150 and 175 degrees C, to establish the transformation products to be expected following migration testing. The half-life at 40 degrees C in distilled water, 15% aqueous ethanol, 3% aqueous acetic acid and olive oil was 15, 23, < 1, > 2000 hr, respectively. The principal product was the diol from hydrolysis of the epoxide group. Ring opening in aqueous ethanol simulant gave the diol and also the glycol monoethyl ether. It is concluded that this instability of styrene oxide will reduce concentrations in foods, from an already low migration level to even lower levels with the formation of hydrolysis products that are less toxic than the parent epoxide.