Oxygenation par le peroxyde d'hydrogene des biomasses fixees utilisees en traitement biologique des eaux

Because of their advantages as compared to flocculated biomass processes, there is now a revival of interest in fixed biomass processes:no mishaps due to bad flocculation, particularly with filamentous organisms (bulking)compact equipment owing to the ability to obtain greater biomass concentrations (several g l⁻¹), which is impossible in flocculated biomass.In this paper, we will consider mainly bio-discs and submerged fixed bed filters. In bio-disc investigations, Hoehn and Ray's (1973), Kornegay and Andrew's (1968) now classical results showed that the bacterial film only acts on the surface, over a thickness which, at best, does not exceed 150 μm. At the same time, Bungay's (1969) very accurate measurements showed that the film active thickness coincides with the depth where the oxygen concentration in the film is higher than the critical oxygen concentration. In submerged filters, Elmaleh (1976) and Grasmick's (1978) theoretical studies permit one to define a Useful Column Height (UCH) which corresponds to the active part of the reactor and which is superposed on the height where oxygen concentration is higher than the critical oxygen concentration. In classical devices, the UCH is relatively low: approx. 0.50-1 m. In both cases, the system is provided with oxygen through an exchange between the air and the effluent to be treated, at a gas-liquid interface. This procedure limits the O₂ concentration to about 9 mg O₂ l⁻¹, at the ambient temperature. Therefore, to increase the UCH of a submerged reactor or the active thickness of a bio-disc film by increasing the oxygen penetrating depth, the oxygen partial pressure in the gas phase should be increased by either using pure oxygen or increasing total gas phase pressure.These two methods are somewhat difficult to use and we prefer to use another method: bringing dissolved oxygen directly into the liquid phase without the exchange at the gas-liquid interface. This is feasible by using an oxygen liberating labile chemical reagent i.e. hydrogen peroxide. We consider two types of fixed biomasses: the bio-discs and the submerged filters.Bio-discs. The apparatus used is shown in Fig. 1. The utilization of H₂O₂ resulted in a very sharp increase in the substrate removal efficiency. It is observed that the substrate removal efficiency (Figs 5 and 6) and the reduced pollution flux (Figs 4 and 7) show a maximum when these are plotted as a function of the ratio: equivalent quantity of O₂ given by H₂O₂/O₂ demanded by the effluent and as a function of dissolved oxygen in the liquid phase. Moreover, these curves suggest that oxygen acts as an inhibitor and different attempts at modeling, based on standard models of inhibiting effects, lead to the exponential model giving the lowest deviation (Fig. 8).Submerged packed reactors. The apparatus used is shown in Fig. 3. This unit is fed by urban effluents and the oxygenation in the reactor is carried out by using diluted H₂O₂ (0.5-1.5 N).