| 后向线材直径测量系统的研究 |
| |
| 引用本文： | 庄春意,张全法,齐永奇.后向线材直径测量系统的研究[J].中原工学院学报,2007,18(2):45-48. |
| |
| 作者姓名： | 庄春意 张全法 齐永奇 |
| |
| 作者单位： | 郑州大学,物理工程学院,郑州,450052 |
| |
| 摘 要： | 基于后向测量法设计了线材直径测量系统,用2片光电池分别测量光源光强和信号光强,经过适当处理后做除法运算,可较好地消除光源光强波动的影响．利用光电池的积分效应能克服线材表面各处反射率不同的影响．在线材直径为1～6 mm时,实验结果的最大相对误差为1．1％．
|
| 关 键 词： | 非接触测量 线材直径 后向测量 光电池 |
| 文章编号： | 1671-6906(2007)02-0045-03 |
| 修稿时间： | 2006年12月28 |
Study on the Backward Diameter Measurement System of Wire Rod |
| |
| ZHUANG Chun-yi,ZHANG Quan-fa,QI Yong-qi.Study on the Backward Diameter Measurement System of Wire Rod[J].Journal of Zhongyuan Institute of Technology,2007,18(2):45-48. |
| |
| Authors: | ZHUANG Chun-yi ZHANG Quan-fa QI Yong-qi |
| |
| Abstract: | Using two photocells to measure the intensity of source light and signal light, divide operation is done after some processing of the photocell signals to eliminate the influence of the instability of the source light radiator. The influence of the fluctuating reflective ratio of the wire rod can be reduced by the integral effect of photocell. The maximum relative error is 1. 1 percent while the wire rod diameter is in the range from 1 mm to 6 mm in experiment. |
| |
| Keywords: | non-contact measurement diameter of wire rod backward measurement photocell |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
