Improvement in Quality and Yield of the Low Alloy Steel Ingot Casting Through Modified Mould Design

The internal quality and yield in 4 ton steel ingot of 40cmd8 grade was studied by comparing its solidification in a square cross-section mould with a slender rectangular cross-section mould, using FEM simulation. The model predicted various solidification aspects like fluid flow, thermal and solidification profiles, mushy zone, local solidification time, porosity and piping for both the molds. The convective flow of the molten metal during solidification showed higher velocity in square ingot than rectangular ingot under similar conditions due to lower surface area to volume ratio that affected the heat transfer in the rectangular ingot. Higher amount of air gap between the ingot and the mould was formed in rectangular ingots. Lower microsegregation as measured in terms of local solidification time was observed in rectangular ingot. Based on microstructure parameters such as thermal gradient and rate of solidification, it was found that the square ingot had more equiaxed zone than rectangular ingot. The rectangular ingot solidified at a faster rate and showed more propensity for core porosity than the square ingot. The ingot yield was improved by 3.6% through mould shape modification from square to rectangular. Model was validated to limited extent by carrying out a typical experiment with square mould.