| Abstract: | The measurement of angular neutron spectrum in a quasi-spherical pile of Ti was carried out by the linac time-of-flight method for the assessment of neutron cross sections for Ti in the energy range from a few keV to a few MeV. The measured spectrum in the pile is generally in good agreement with the calculated one from ENDF/B-IV (MAT = 1,286 for Ti) except in the energy range from about 60 keV to a few 100 keV, where the calculation gives considerably lower neutron flux than the measurement. In order to investigate the cause of this discrepancy between the measured and calculated spectra, the total cross sections for Ti were measured by the transmission method. The results give larger values of total cross sections for Ti by about 30% than ENDF/B-IV below 200 keV, and smaller values by about 10% above 200 keV. These results were ensured at 55 and 147 keV by the measurement using a Si-filtered neutron beam. The calculation based on the measured cross sections shows better agreement with the measured spectrum than that based on ENDF/B-IV. The discrepancy is still observed around 100 keV. The sensitivity analysis shows the importance of cross sections above 1 MeV and elastic cross sections in the resonance energy region to solve the disagreement between the measured spectrum and the calculated one. |
