首页 | 本学科首页   官方微博 | 高级检索  
     

木塑/超临界流体复合材料泡孔成核的数值模拟研究
引用本文:张婧婧. 木塑/超临界流体复合材料泡孔成核的数值模拟研究[J]. 中国塑料, 2010, 24(11): 80-83. DOI: 10.19491/j.issn.1001-9278.2010.11.021
作者姓名:张婧婧
作者单位:广东工业大学
摘    要:以木塑/超临界二氧化碳(WPC/Sc-CO2)复合材料为研究对象,采用有限元分析软件Polyflow对不同尺寸的挤出发泡机头内的流场进行数值模拟,研究机头尺寸对WPC/Sc-CO2复合材料泡孔成核的影响。结果表明,增加挤出发泡机头内毛细管段长度对机头内压力降速率和泡孔成核点距离机头出口的位置影响很小;而减小挤出发泡机头内毛细管段直径可增加机头内压力降速率,同时使泡孔成核点的位置更靠近机头出口。

关 键 词:木塑复合材料  超临界流体  泡孔成核  数值模拟  
收稿时间:2010-06-23

Numerical Simulation of the Cell Nucleation Location of WPC/Supercritical Fluid Composites
Abstract:Flow field simulation of WPC/supercritical CO2(WPC/Sc-CO2) composites flowing through an extrusion foaming die with different die dimension were performed by FEM software Polyflow, and the effects of foaming die dimension on the cell nucleation of WPC/Sc-CO2 composites were investigated. It was found that increasing the capillary length of the foaming die had little effect on the pressure drop rate and the distance from cell nucleation point to die exit. By decreasing the capillary diameter of the foaming dies, a large pressure drop rate was created, and the cell nucleation point location moved toward the die exit.
Keywords:wood-plastic composite  supercritical fluid  cell nucleation  numerical simulation  
本文献已被 CNKI 等数据库收录!
点击此处可从《中国塑料》浏览原始摘要信息
点击此处可从《中国塑料》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号