Hybrid laser/arc welding of advanced high strength steel in different butt joint configurations

An experimental procedure was developed to join thick advanced high strength steel plates by using the hybrid laser/arc welding (HLAW) process, for different butt joint configurations. The geometry of the weld groove was optimized according to the requirements of ballistic test, where the length of the softened heat affected zone should be less than 15.9 mm from the weld centerline. The cross-section of the welds was examined by microhardness test. The microstructure of welds was investigated by scanning electron microscopy and an optical microscope for further analysis of the microstructure of fusion zone and heat affected zone. It was demonstrated that by changing the geometry of groove, and increasing the stand-off distance between the laser beam and the tip of wire in gas metal arc welding (GMAW) it is possible to reduce the width of the heat affected zone and softened area while the microhardness stays within the acceptable range. It was shown that double Y-groove shape can provide the optimum condition for the stability of arc and laser. The dimensional changes of the groove geometry provided substantial impact on the amount of heat input, causing the fluctuations in the hardness of the weld as a result of phase transformation and grain size. The on-line monitoring of HLAW of the advanced high strength steel indicated the arc and laser were stable during the welding process. It was shown that less plasma plume was formed in the case where the laser was leading the arc in the HLAW, causing higher stability of the molten pool in comparison to the case where the arc was leading.