|
|||||
|
|
| ZL21滤棒成型机组生产水溶性加胶棒的设备改造 | |
| 引用本文： | 崔庆军,丁晓卫,王馨,鲍峰伟. ZL21滤棒成型机组生产水溶性加胶棒的设备改造[J]. 烟草科技, 2011, 0(8) |
| 作者姓名： | 崔庆军 丁晓卫 王馨 鲍峰伟 |
| 作者单位： | 1. 河北中烟工业公司技术中心,石家庄市珠江大道366号,050035 2. 张家口卷烟厂有限责任公司,河北省张家口市钻石北路9号,075000 3. 河北白沙烟草有限责任公司石家庄卷烟厂,石家庄市珠江大道366号,050035 |
| 摘 要： | ZL21滤棒成型机组生产水溶性加胶棒时,由于水溶性胶具有含水率高、粘度大、流动性差等特点,造成甩胶轮甩出的水溶胶穿透性差且不均匀、水溶性胶变干后粘结在泵体上导致泵体频繁损坏、铜质的上胶及回胶管路遇水易产生铜锈、烘烤后滤棒易弯曲变形等问题.为此对ZL21成型机组及烘箱进行了6项改造:甩胶电机转速由原来的1400 r/min改为2800 r/min,甩胶轮由单排甩胶孔改为3排甩胶孔;上胶泵由齿轮泵改为蠕动泵,上胶及回胶管路改为增塑网管,加装过滤网和弧形开松杆,优化烘箱参数.改造后应用结果表明,实现了水溶性加胶棒在ZL21成型机组上的正常生产,设备有效作业率达到90％以上,产品质量满足了工艺质量要求,平均质量合格率达到97％以上. |
| 关 键 词： | ZL21滤棒成型机组 水溶性胶 甩胶轮 烘箱 |
Modification of Equipments to Produce Water-soluble Glue-added Filter Rod in ZL21 Filter Rod Maker |
|
| CUI QING-JUN,DING XIAO-WEI,WANG XIN,BAO FENG-WEI. Modification of Equipments to Produce Water-soluble Glue-added Filter Rod in ZL21 Filter Rod Maker[J]. Tobacco Science & Technology, 2011, 0(8) | |
| Authors: | CUI QING-JUN DING XIAO-WEI WANG XIN BAO FENG-WEI |
| Affiliation: | CUI QING-JUN(1),DING XIAO-WEI(2),WANG XIN(3),and BAO FENG-WEI(1) 1.Technology Center,China Tobacco Hebei Industrial Corporation,Shijiazhuang 050035,China 2.Zhangjiakou Cigarette Factory Co.,Ltd.,Zhangjiakou 075000,Hebei,China 3.Shijiazhuang Cigarette Factory,HBBS Tobacco Co.,China |
| Abstract: | When water-soluble glue-added filter rod is produced in ZL21 filter rod maker,the high moisture content,high viscosity and poor fluidity of the glue causes some troubles in machine operation,such as the glue is not evenly applied,the dried glue tends to buildup on the pump body and resulting in frequent pump damage,copper pipes rust,and the filter rods are liable to be distorted by oven-drying.Therefore,ZL21 filter rod maker and oven were improved as following:raising the rotation speed of applicator motor ... |
| Keywords: | ZL21 filter rod maker Water-soluble glue Glue applicator disk Oven |
| 本文献已被 CNKI 万方数据 等数据库收录！ | |