Tribological behaviour of proposed polymeric bearing materials

The aim of the present work is to introduce new polymeric bearing materials. The proposed polymeric composites are consisting of polyethylene (PE), polypropylene (PP) and polystyrene (PS) and filled by fibres of polytetrafluoroethylene (PTFE) in concentration up to 25 wt.% as well as different types of natural oils such as (corn oil, olive oil, paraffin oil, glycerin oil, castor oil and sunflower oil) in concentration up to 10 wt.%. The frictional behavior of the proposed composites and wear resistance are investigated at different values of applied load. Based on the experimental observations, it was found that for composites free of oil, friction of PS and PE specimens decreased, while friction of PP specimens slightly increased with increasing PTFE content. PP composites filled by corn oil showed slight friction increase. Besides, friction coefficient displayed by PS and PE specimens filled by glycerin oil decreased with increasing oil content, while friction coefficient displayed by PP specimens showed consistent trend. It was noted that, PE filled with 7.5% glycerin oil and 20 wt.% PTFE displayed the minimum value of friction coefficient (0.07). This friction coefficient values recommend those composites to be used as bearing materials. PE filled by glycerin oil displayed relatively lower friction values due its common known good lubricating property. Friction of PE composites filled by paraffin oil drastically decreased with the increasing oil content. PP composites showed the lowest wear values. In addition to that, it was shown that wear displayed by composites filled by glycerin oil was higher than that containing corn oil, while wear of the tested composites filled with olive oil showed lower values than that displayed by corn oil filled composites. Composites containing 5.0–7.5% paraffin oil content showed good wear resistance which recommends them to be used as bearing material. Wear of PP, PS and PE composites filled with sunflower oil and 15 wt.% PTFE drastically decreased with increasing oil content. The minimum wear was displayed by PP and PE composites filled with 10% oil content.