| 基于USB通信的多轴联动曲面加工示教系统 |
| |
| 引用本文： | 吴昌林,景胜春.基于USB通信的多轴联动曲面加工示教系统[J].机械与电子,2007(7):34-37. |
| |
| 作者姓名： | 吴昌林 景胜春 |
| |
| 作者单位： | 华中科技大学机械科学与工程学院,湖北,武汉,430074 |
| |
| 摘 要： | 从硬件设计、固件程序设计和用户软件设计3个方面,阐述了便捷实用的多轴联动曲面加工示教系统的设计和实现方法,该系统应用USB接口芯片PDIUSBD12,通过与微控制器AT89S52互连,实现与可编程定时计数器8253的数据接受和传送.
|
| 关 键 词： | USB总线 示教系统 固件设计 用户程序 通信 多轴联动 曲面加工 示教系统 Communication Based Milling Controlled Curved Face Teaching System 数据 定时计数器 可编程 微控制器 接口芯片 系统应用 方法 软件设计 阐述 用户 |
| 文章编号： | 1001-2257（2007）07-0034-04 |
| 修稿时间： | 2006-12-18 |
Method of Teaching System of Curved Face Multi-axes Simultaneous Controlled Milling Based on USB Communication |
| |
| WU Chang-lin,JING Sheng-chun.Method of Teaching System of Curved Face Multi-axes Simultaneous Controlled Milling Based on USB Communication[J].Machinery & Electronics,2007(7):34-37. |
| |
| Authors: | WU Chang-lin JING Sheng-chun |
| |
| Affiliation: | School of Mechanical Science and Engineering,Huazhong University of Science and Technology,Wuhan 430074,China |
| |
| Abstract: | Dwelt on hardware design,firmware program frame and customer software method,and provided a simple and convenient design for curved face multi-axes simultaneous controlled milling teaching system.In this system,PDIUSBD12 is USB interface chip,which receives or transmits data with the programmed timer/counter 8253.And MCU managed USB and their communication. |
| |
| Keywords: | USB BUS teaching system firmware design customer program |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
