Characteristics of copper oxide films deposited by PBII&D |
| |
| Authors: | Xinxin Ma Gang Wang Mingren Sun |
| |
| Affiliation: | a School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, PR China
b Department of Electrical Engineering, Faculty of Engineering, Doshisha University, 1-3 Tatara-Miyakodani, Kyotanabe, Kyoto 610-0321, Japan |
| |
| Abstract: | Copper oxide films were deposited by plasma based ion implantation and deposition using a copper antenna as rf sputtering ion source. A gas mixture of Ar + O2 was used as working gas. During the process, copper that was sputtered from the rf antenna reacted with oxygen and was deposited on a silicon substrate. The composition and the chemical state of the deposited films were analyzed by XPS. The structure of the films was detected by XRD. It is observed that Cu2O film has been prepared on the Si substrate. It is found that the microstructure of the deposited film is amorphous for the applied voltage of − 5 kV. The surface layer of the deposited films is CuO. This is because the surface layer absorbs the oxygen from ambient air after the treated sample was removed from the vacuum chamber. An appropriate applied voltage, 2 kV under the present conditions, brings the lowest resistance. It is also seen that the maximum absorbance of the deposited films moves to a lower wavelength with increased applied voltage. |
| |
| Keywords: | 81 15 -z 68 55 -a 73 90 +f 78 20 -e |
| 本文献已被 ScienceDirect 等数据库收录！ |
|
