| UG软件在26×4.0全地形自行车轮胎花纹设计及优化中的应用 |
| |
| 引用本文： | 聂三军,杨金林.UG软件在26×4.0全地形自行车轮胎花纹设计及优化中的应用[J].轮胎工业,2013,33(8):463-467. |
| |
| 作者姓名： | 聂三军 杨金林 |
| |
| 作者单位： | 1. 青岛科技大学高分子科学与工程学院,山东青岛266042;杭州中策橡胶有限公司,浙江杭州310008
2. 浙江理工大学国家级机械基础实验教学示范中心,浙江杭州,310018 |
| |
| 摘 要： | 介绍UG软件在26×4.0全地形自行车轮胎花纹设计及优化中的应用。确定轮胎花纹的基本形式后,制定轮胎造型的基本流程,采用Auto CAD绘制轮胎花纹和轮胎断面曲线的二维图,再导入UG软件进行轮胎花纹3D建模,然后对花纹形式、花纹深度、花纹沟断面形状和花纹饱和度等进行优化设计,最后渲染出整条轮胎效果图。
|
| 关 键 词： | UG软件 全地形自行车轮胎 花纹设计 |
Application of UG Software in Design and Optimization for Tread Pattern of 26 × 4.0 All Terrain Bike Tire |
| |
| NIE San-jun and YANG Jin-lin.Application of UG Software in Design and Optimization for Tread Pattern of 26 × 4.0 All Terrain Bike Tire[J].Tire Industry,2013,33(8):463-467. |
| |
| Authors: | NIE San-jun and YANG Jin-lin |
| |
| Affiliation: | 1.Qingdao University of Science and Technology,Qingdao 266042,China;2.Hangzhou Zhongce Rubber Co.,Ltd,Hangzhou 310008, China;3.Zhejiang Sci-Tech University,Hangzhou 310018,China) |
| |
| Abstract: | The application of UG software in the design and optimization for the tread pattern of 26×4.0 all terrain bike tire was introduced.The tire modeling was carried out after the basic pattern form of the tire was determined.Firstly,the two dimensional drawing of the tread pattern and cross sectional profile were acquired by using Auto CAD software,and then the 3D model of tread pattern was built by importing the two dimensional drawing in UG software.Finally,the pattern form,block depth,groove section shape and block/total ratio were optimized and the overall drawing was obtained. |
| |
| Keywords: | |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《轮胎工业》浏览原始摘要信息 |
|
点击此处可从《轮胎工业》下载全文 |
|
