首页 | 本学科首页   官方微博 | 高级检索  
     

基于MATLAB/Simulink的压裂泵流量脉动抑制研究
引用本文:李永涛,木合塔尔·克力木,杨波.基于MATLAB/Simulink的压裂泵流量脉动抑制研究[J].机床与液压,2023,51(2):169-173.
作者姓名:李永涛  木合塔尔·克力木  杨波
作者单位:新疆大学机械工程学院
基金项目:“天池博士计划”科研基金资助项目(tcbs201921);新疆大学博士启动项目(BS1902018)
摘    要:针对压裂泵流量脉动及压力脉动特性,提出蓄能器-增压缸组合式流体脉动抑制方法,并基于MATLAB/Simulink建立压裂泵及脉动抑制回路的数学模型,根据理论、仿真对比分析了该脉动抑制方法对流量脉动抑制效果。结果表明:蓄能器容积和预充气压力可显著影响流量脉动;当预充气压力为4 MPa、容积为6 L时,流量和压力脉动率分别从39.99%和76.93%降至2.47%和4.89%。

关 键 词:压裂泵  流量脉动  蓄能器-增压缸组合  脉动抑制

Study on Flow Pulsation Suppression of Fracturing Pump Based on MATLAB/Simulink
LI Yongtao,MUHETAER Kelimu,YANG Bo.Study on Flow Pulsation Suppression of Fracturing Pump Based on MATLAB/Simulink[J].Machine Tool & Hydraulics,2023,51(2):169-173.
Authors:LI Yongtao  MUHETAER Kelimu  YANG Bo
Abstract:In view of the characteristics of flow pulsation and pressure pulsation of fracturing pump, a combined accumulator and pressurized cylinder fluid pulsation suppression method was proposed, and a mathematical model of fracturing pump and pulsation suppression circuit was established based on MATLAB/Simulink. The effect of the pulsation suppression method was compared and analyzed according to theory and simulation analysis.The simulation results show that the accumulator volume and precharging pressure can significantly affect the flow pulsation;when the precharging pressure is 4 MPa and the volume is 6 L, the flow rate and pressure pulsation rate decrease from 39.99% and 76.93% to 2.47% and 4.89% respectively.
Keywords:Fracturing pump  Flow pulsation  Combination of accumulator-booster cylinder  Pulsation suppression
点击此处可从《机床与液压》浏览原始摘要信息
点击此处可从《机床与液压》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号