首页 | 本学科首页   官方微博 | 高级检索  
     

一种接收前端三级低噪声放大器的设计
引用本文:周志增,刘洪亮,刘鹏,梅永华.一种接收前端三级低噪声放大器的设计[J].现代电子技术,2010,33(12):5-7.
作者姓名:周志增  刘洪亮  刘鹏  梅永华
作者单位:解放军63889部队,河南,孟州,454750
摘    要:针对单片雷达接收机中对低噪声放大器(LNA)的要求,采用CMOS0.18,um工艺设计了一个三级级联的镜像抑制低噪声放大器。通过在低噪声放大器中接入限波滤波器,实现对镜像信号的衰减,从而减小了后端混频器电路的设计难度。在ADS中对设计的放大器仿真,其结果为:最大供电电压为5V情况下,信号频段为3.0~3.2GHz,中频输出为225MHz,功率增益≥31dB,噪声系数(FN)≤O.5dB,1dB点的输入/输出功率分别为-19.5dBm和11.5dBm,对镜像信号的抑制度达22dB。

关 键 词:CMOS  低噪声放大器  噪声系数  镜像抑制  镜像信号  陷波滤波器

Design of Three-level Low-noise Amplifier at Front End of Receiver
ZHOU Zhi-zeng,LIU Hong-liang,LIU Peng,MEI Yong-hua.Design of Three-level Low-noise Amplifier at Front End of Receiver[J].Modern Electronic Technique,2010,33(12):5-7.
Authors:ZHOU Zhi-zeng  LIU Hong-liang  LIU Peng  MEI Yong-hua
Affiliation:ZHOU Zhi-zeng,LIU Hong-liang,LIU Peng,MEI Yong-hua(Unit 63889 of PLA,Mengzhou 454750,China)
Abstract:Three-level low-noise amplifier with image rejection was designed by the aid of the CMOS 0.18 btm technology to meet the requirement of the low-noise amplifier (LNA) in the radar receiver. With the notch filter in the LNA, it can reject the image signal which makes the circuit design of the mixer at the rear end easier. The designed amplifier is simulated in the ADS software. The simulation result is: under the condition of maximum supplied voltage 5 V, the band of the signal is 3.0 -3.2 GHz, IF output is 225 MHz, power gain ≥31 dB, noise figure 40.5 dB, input and output 1 dB, power of the points is -19.5 dBm and 11.5 dBm respectively and the rejection of the image signal reaches 22 dB.
Keywords:CMOS
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号