| 细钼丝聚晶拉丝模孔型参数的探讨 |
| |
| 引用本文： | 黄立峰,李世伟,刘宝庆,卜春阳.细钼丝聚晶拉丝模孔型参数的探讨[J].中国钼业,2013(4):46-49. |
| |
| 作者姓名： | 黄立峰 李世伟 刘宝庆 卜春阳 |
| |
| 作者单位： | 金堆城钼业光明(山东)股份有限公司;金堆城钼业股份有限公司技术中心 |
| |
| 摘 要： | 结合工厂生产实际，应用CU-10检测仪对细钼丝拉丝模主要孔型参数的变化情况进行跟踪检测，例如压缩角、定径区长度、椭圆度等，对比分析确定其最佳工作参数控制范围，以提高拉丝模使用质量和工作寿命。
|
| 关 键 词： | 钼丝 拉丝模 压缩角 定径区 椭圆度 |
DISCUSSION ON THE POLYCRYSTALLINE WORTLE PASS PARAMETERS OF FINE MOLYBDENUM WIRES |
| |
| HUANG Li-feng;LI Shi-wei;LIU Bao-qing;BU Chun-yang.DISCUSSION ON THE POLYCRYSTALLINE WORTLE PASS PARAMETERS OF FINE MOLYBDENUM WIRES[J].China Molybdenum Industry,2013(4):46-49. |
| |
| Authors: | HUANG Li-feng;LI Shi-wei;LIU Bao-qing;BU Chun-yang |
| |
| Affiliation: | HUANG Li-feng;LI Shi-wei;LIU Bao-qing;BU Chun-yang;Jinduicheng Molybdenum Guangming(Shandong)Co.,Ltd.;Technical Center,Jinduicheng Molybdenum Co.,Ltd.; |
| |
| Abstract: | The pass parameter changing of fine molybdenum wire are detected by CU - 10 Inspector in accordance with factory~ actual processing, such as compression angle, length of the sizing area, ovality, and etc. Then the best operat- ing scope of pass parameter is determined so that the drawing dies＇quality and operating life are improved. |
| |
| Keywords: | molybdenum wire drawing die compression angle sizing area ovality |
| 本文献已被 CNKI 维普 等数据库收录！ |
