|
|||||
|
|
| 嵌件注射成型工艺的分析与优化 | |
| 引用本文： | 李林楠,杨音文,李庆,佟玉斌,黄志高,周华民.嵌件注射成型工艺的分析与优化[J].塑料工业,2012,40(3):84-87. |
| 作者姓名： | 李林楠 杨音文 李庆 佟玉斌 黄志高 周华民 |
| 作者单位： | 1. 华中科技大学材料成形与模具技术国家重点实验室,湖北武汉,430074 2. 武汉美嘉机械塑料有限公司,湖北武汉,430065 3. 华中科技大学材料成形与模具技术国家重点实验室,湖北武汉430074;烟台职业学院机械工程系,山东烟台264670 |
| 摘 要： | 以某品牌轿车车身B柱外饰件为例,分析了嵌件注射成型工艺中熔合纹和翘曲缺陷产生的原因；并通过数值模拟和实验对比,提出了预测和修正制品缺陷的思路和方法. |
| 关 键 词： | 嵌件注射 熔合纹 翘曲 CAE |
Analysis and Optimization on Injection Insert Molding Processing |
|
| LI Lin-nan , YANG Yin-wen , LI Qing , TONG Yu-bin , HUANG Zhi-gao , ZHOU Hua-min.Analysis and Optimization on Injection Insert Molding Processing[J].China Plastics Industry,2012,40(3):84-87. | |
| Authors: | LI Lin-nan YANG Yin-wen LI Qing TONG Yu-bin HUANG Zhi-gao ZHOU Hua-min |
| Affiliation: | 1(1.State Key Laboratory of Material Processing and Die&Mould Technology,Huazhong University of Science and Technology,Wuhan 430074,China; 2.Wuhan Mecaplast Mechanical Plastic Limited Company,Wuhan 430065,China; 3.Mechanical Engineering Faculty of Yantai Vocational College,Yantai 264670,China) |
| Abstract: | This paper discussed an insert molding processing optimization case of plastic exterior trim on an automobile body B pillar.The causes of weld line and warpage defects were analyzed based on CAE numerical simulation as well as experiment comparison,and the corresponding optimization suggestions were proposed. |
| Keywords: | Insert Molding Weld Line Warpage CAE |
| 本文献已被 CNKI 万方数据 等数据库收录！ | |