首页 | 本学科首页   官方微博 | 高级检索  
     

两流板坯连铸中间包结构优化水模实验研究
引用本文:胡鹏,陈远清,张慧,周俐.两流板坯连铸中间包结构优化水模实验研究[J].沈阳黄金学院学报,2011(2):82-84,87.
作者姓名:胡鹏  陈远清  张慧  周俐
作者单位:[1]钢铁研究总院国家连铸中心,北京100081 [2]安徽工业大学冶金与资源学院,安徽马鞍山243002
摘    要:通过两流板坯中间包水模实验,研究了抑湍器以及不同控流装置的组合对中间包流动特性的影响.结果表明,合理使用抑湍器能延长开始响应时间,提高平均停留时间和活塞流体积.抑湍器和垱坝组合控流效果良好,且结构简单.由抑湍器、垱坝和挡渣堰组成的控流装置使中间包流场更加合理,优化后的中间包平均停留时间由原先的188 s提高到218 s,活塞流体积分数由3.50%提高到15.41%,死区体积分数由41.57%降低到32.15%.

关 键 词:板坯连铸  中间包  控流装置  水模

Water modeling study on optimization of structure in two-strand tundish for slab concasting
Authors:Hu Peng  Chen Yuan-qing  Zhang Hui  Zhou Li
Affiliation:1.National Engineering and Research Center for Continuous Casting Technology,Center Iron and Steel Institute,Beijing 100081;2.School of Metallurgical and Resource,University of Technology Anhui,Maanshan 243002,Anhui)
Abstract:The effect of control devices on fluid flow in two-strand tundish for slab continuous casting was investigated by water modeling,and the characteristics of flow with or without turbulence inhibitors was also studied.It is obtained that with the reasonable arrangement of turbulence inhibitor,the response time increased greatly,as well as the average residence time and plug flow volume increased.The turbulence inhibitor could get a good effect with one dam,and its structure is simple.The flow field in tundish would be more rational by the flow control device which consisted of turbulence inhibitors,dam and weir.After optimum,the average residence time increased to 218 s from 188 s,plug flow volume increased to 15.41% from 3.5%,and zone volume decreased from 41.57% to 32.15%.
Keywords:slab continuous casting  tundish  flow control device  water modeling
本文献已被 维普 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号