首页 | 本学科首页   官方微博 | 高级检索  
     

基于拓扑组合的高增益Boost变换器
引用本文:罗全明,闫欢,孙明坤,邹灿,周雒维.基于拓扑组合的高增益Boost变换器[J].电工技术学报,2012(6):96-102.
作者姓名:罗全明  闫欢  孙明坤  邹灿  周雒维
作者单位:重庆大学输配电装备及系统安全与新技术国家重点实验室
基金项目:国家自然科学基金(50907076);国家重点实验室自主研究(2007DA10512710202)资助项目
摘    要:提出一种基于拓扑组合的高增益Boost变换器,对其工作原理和性能特点进行了详细分析,并进行了实验研究,结果表明该变换器在开关占空比D>0.5时具有如下特点:①电压增益为基本Boost变换器的两倍;②变换器中两Boost变换单元可实现自动均流,与交错并联Boost变换器相比,不需均流控制,控制电路简单;③有源开关的电压应力为输出电压的一半,即为基本Boost变换器有源开关电压应力的一半。

关 键 词:Boost变换器  开关电感三端网络  高电压增益

High Step-up Boost Converter Based on Topology Combination
Luo Quanming Yan Huan Sun Mingkun Zou Can Zhou Luowei.High Step-up Boost Converter Based on Topology Combination[J].Transactions of China Electrotechnical Society,2012(6):96-102.
Authors:Luo Quanming Yan Huan Sun Mingkun Zou Can Zhou Luowei
Affiliation:Luo Quanming Yan Huan Sun Mingkun Zou Can Zhou Luowei(Chongqing University State Key Laboratory of Power Transmission Equipment and System Safety and New Technology Chongqing 400044 China)
Abstract:The high step-up Boost converter based on topology combination is proposed in this paper.The operation principle and property of the converter are analyzed in detail.The experimental results are given.When duty ratio D>0.5,the converter has these characteristics as follows: Firstly,the voltage gain is double of the basic Boost converter.Secondly,the two Boost cell of the converter can realize current sharing automatically,which is unlike the interleaved Boost converter,and therefore,the control circuit is simple.Finally,the voltage stress of the active switch is half of the output voltage,namely,it is half of the voltage stress of the basic Boost converter.
Keywords:Boost converter  three-teminal switch-inductor network  high voltage gain
本文献已被 CNKI 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号