| 实现三维喷绘的软件系统设计 |
| |
| 引用本文： | 赵志远,陈宇拓,费勇超.实现三维喷绘的软件系统设计[J].现代计算机,2011(Z1):109-112. |
| |
| 作者姓名： | 赵志远 陈宇拓 费勇超 |
| |
| 作者单位： | 中南林业科技大学计算机与信息工程学院; |
| |
| 基金项目： | 湖南省自然科学基金资助项目(No.08JJ3009); 湖南省科技计划项目(No.2006GK3090) |
| |
| 摘 要： | 对三维喷绘软件系统的设计,通过USB 2.0实现与喷绘主板的高速图像数据通信。基于ARM与MCX314的运动控制器实现实时三轴运动控制以及精确的喷头时序控制,论述USB驱动程序和ARM固件的开发。结果表明,该系统具有设计简洁、成本低、可扩展性强和实用性高等特点。
|
| 关 键 词： | 三维 喷绘 软件系统 USB2.0 ARM |
Design of Implementation of Three-Dimensional Printing of Software System |
| |
| ZHAO Zhi-yuan,CHEN Yu-tuo,FEI Yong-chao.Design of Implementation of Three-Dimensional Printing of Software System[J].Modem Computer,2011(Z1):109-112. |
| |
| Authors: | ZHAO Zhi-yuan CHEN Yu-tuo FEI Yong-chao |
| |
| Affiliation: | ZHAO Zhi-yuan,CHEN Yu-tuo,FEI Yong-chao (School of Computer Science and Information Engineering,Central South University of Forestry and Technology,Changsha 410004) |
| |
| Abstract: | By using the USB 2.0 interface chip,realizes the high-speed data transmission with printing board.The motion controller based on ARM and MCX314 realizes real-time three-axis motion control and accurate nozzle sequence control,discusses the design of USB device drivers and ARM firmware briefly.The result indicates that the system has simple in design,low cost,good extensibility and high practicability. |
| |
| Keywords: | Three-Dimensional Printing Software System USB 2 0 ARM |
| 本文献已被 CNKI 等数据库收录！ |
