首页 | 本学科首页   官方微博 | 高级检索  
     

基底温度对直流溅射Nb掺杂TiO2薄膜性能的影响
引用本文:黄帅,李晨辉,孙宜华,柯文明.基底温度对直流溅射Nb掺杂TiO2薄膜性能的影响[J].无机材料学报,2012(1):64-68.
作者姓名:黄帅  李晨辉  孙宜华  柯文明
作者单位:华中科技大学材料成型与模具技术国家重点实验室;三峡大学机械与材料学院
基金项目:国家自然科学基金(50074017)~~
摘    要:采用陶瓷靶直流磁控溅射,以玻璃为基底制备2.5wt%Nb掺杂TiO2薄膜,控制薄膜厚度在300~350 nm,研究了不同基底温度下所制得薄膜的结构、形貌和光学特性.XRD分析表明,基底温度为150℃、250℃和350℃时,薄膜分别为非晶态、锐钛矿(101)和金红石相(110)结构.基底温度250℃时,锐钛矿相薄膜的晶粒尺寸最大,约为32 nm.薄膜表面形貌的SEM分析显示,薄膜粗糙度和致密度随基底温度升高得到改善.薄膜的平均可见光透过率在基底温度为250℃以内约为70%,随基底温度升高至350℃,平均透过率下降为59%,金红石相的存在不利于可见光透过.Nb掺杂TiO2薄膜的光学带宽在3.68~3.78 eV之间变化.基底温度为250℃时,锐钛矿相薄膜的禁带宽度最大,为3.78 eV.

关 键 词:基底温度  TiO2  直流磁控溅射  陶瓷靶  显微结构  光学特性

Influence of the Substrate Temperature on the Properties of Nb-doped TiO2 Films Deposited by DC Magnetron Sputtering
HUANG Shuai,LI Chen-Hui,SUN Yi-Hua,KE Wen-Ming.Influence of the Substrate Temperature on the Properties of Nb-doped TiO2 Films Deposited by DC Magnetron Sputtering[J].Journal of Inorganic Materials,2012(1):64-68.
Authors:HUANG Shuai  LI Chen-Hui  SUN Yi-Hua  KE Wen-Ming
Affiliation:1(1.State Key Laboratory of Material Processing and Die & Mould Technology,Huazhong University of Science and Technology Department of Material Science and Engineering,Wuhan 4300074,China;2.College of Mechanical & Material Engineering,China Three Gorges University,Yichang 443002,China)
Abstract:Nb-doped(2.5wt%) TiO2 thin films was deposited on glass substrate by DC magnetron sputtering from a ceramic target and the films thickness was controlled in the range from 300 nm to 350 nm.The structure,surface morphology and optical properties of the films deposited at different substrate temperatures were investigated by X-ray diffraction,scanning electron microscope,and optical transmission spectroscope.The films deposited at 150℃,250℃ and 350℃ were amorphous,anatase and rutile,respectively.The grain size of the typical anatase film deposited at 250℃ reached the maximum of 32 nm.The roughness of the films decreased and their density increased with the rising of substrate temperature.The average optical transmittance of films were around 70% when the substrate temperatures were below 250℃.As the substrate temperature were risen to 350℃,the films’ transmittance dropped to 59%.It indicated that the transmittance of visible light was hindered by the rutile phase in the Nd-doped TiO2 films.The optical band gap of the films were in the range from 3.68 eV to 3.78 eV,and the optical band gap of the typical anatase film deposited at 250℃ reached the highest value of 3.78 eV.
Keywords:substrate temperature  TiO2  DC magnetron sputtering  ceramic target  structure  optical properties
本文献已被 CNKI 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号