| 等离子喷涂WC/18Co涂层微动磨损机理的研究 |
| |
| 引用本文： | 徐向阳,左铁镛,徐滨士,刘世参.等离子喷涂WC/18Co涂层微动磨损机理的研究[J].材料保护,2001,34(5):1-3. |
| |
| 作者姓名： | 徐向阳 左铁镛 徐滨士 刘世参 |
| |
| 作者单位： | 1. 北京工业大学材料学院
2. 全军装备维修表面工程研究中心 |
| |
| 基金项目： | 国防科技重点实验室资助! (合同号 98JS5 0 .2 .1JB35 0 1) |
| |
| 摘 要： | 研究了等离子喷涂WC/18Co涂层的微动磨损机理，结果表明，涂层的微动磨损开始阶段以粘着磨损为主，涂层硬度高，抗粘着能力强，磨损轻微；稳定阶段以疲劳脱层和脆性开裂剥落为主，涂层脆性大，喷涂粒子间结合强度低，容易磨损。喷涂层内部的氧化物夹杂是造成涂层抗微动磨损能力不足的主要原因。
|
| 关 键 词： | 等离子喷涂 钴包碳化钨 涂层 微动磨损 |
| 文章编号： | 1001-1560(2001)05-0001-03 |
| 修稿时间： | 2000年11月20 |
Fretting Wear Mechanism of Plasma Sprayed WC/18Co Coating |
| |
| XU Xiang yang.Fretting Wear Mechanism of Plasma Sprayed WC/18Co Coating[J].Journal of Materials Protection,2001,34(5):1-3. |
| |
| Authors: | XU Xiang yang |
| |
| Abstract: | The fretting wear mechanism of plasma sprayed WC/18Co coating has been investigated by OM,SEM,EPMA,XRD and profilometer.It was shown that the fretting wear of plasma sprayed WC/18Co coating was mainly adhesive at initial stage,and its fretting wear resistance was higher than that of 1Cr18Ni9Ti stainless steel on account of its high hardness.But at steady stage,the wear mechanism tended to be of surface delamination and fragmentation owing to its brittleness and low adhesive strength.The main factors affecting fretting wear resistance were porosity and oxide inclusions in WC/18Co coating. |
| |
| Keywords: | |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
